Related Manuals for Trac Vac 880
Summarization of Contents
Safety Rules and Precautions
General Safety Guidelines
Covers reading the manual, age restrictions, fuel handling, and heat precautions for safe operation.
Mechanical and Operational Safety
Details safe practices around rotating parts, moving components, and operating conditions like slopes and eye protection.
Assembly Instructions
Step One: Receiving and Inspection
Inspect for shipping damage upon receiving the unit and report any findings immediately.
Step Two: Unpacking and Inventory
Unpack all contents from the crate and carefully check for any remaining parts.
Step Three: Axle Assembly and Subframe Attachment
Begin axle assembly and attach the subframe to the engine frame using specified bolts.
Step Four: Latch Handle Installation
Bolt the pre-assembled latch handle to the subframe base and adjust as needed.
Step Five: Engine Plate Tightening
Ensure the engine plate is securely tightened to the frame for motor stability.
Final Step: Hose Hanger and Strap
Attach the hose hanger and strap, positioning the hose for connection to the mower deck.
Axle and Base Assembly
Step 1: Support Plate and Front Stand
Place the support plate and position the front stand, securing them with bolts and nuts.
Step 2: Angle Stop Installation
Secure the angle stop against the front face of the stand using bolts and nuts.
Step 3: Axle Holder and Support Plates
Install middle and left axle holders and support plates, sliding the axle through the holes.
Step 4: Tilting Hitch Arm and Axle Capture
Place the tilting hitch arm, capture the axle with the right holder, and tighten all remaining supports.
Step 5: Tire Mounting and Securing
Slip spacer tubes and tires onto the axle ends and secure them with washers and pins.
Tractor Attachment Instructions
Hitch Installation
Attach the hitch to the rear of your tractor with the lip upward, using supplied pins or bolts.
Air Turbine Assembly Mounting
Mount the air turbine assembly by hooking the frame onto the hitch and bolting it to the drawbar.
Discharge Chute and Hose Connection
Discharge Chute Mounting
Mount the discharge chute adapter onto the mower deck, aligning holes or marking and drilling.
Hose Attachment
Connect the 60" hose between the air turbine and discharge chute, securing with clamps.
Maintenance Schedule and Procedures
Before Each Use Checks
Perform visual checks for loose hardware, check tire pressure, and verify engine oil level.
Lubrication Points
Lubricate axle pivot points and latch bolts seasonally; grease wheel bearings annually.
Engine Maintenance
Maintain engine oil, service air cleaner regularly, and clean spark plugs seasonally.
Cleaning Instructions
Clean the cart and top after each use; clean the engine with a cloth or brush.
Troubleshooting Guide
Engine Fails to Start
Addresses issues like disconnected spark plug wire, empty fuel tank, or faulty spark plug.
Loss of Power or Erratic Operation
Covers loose spark plug wire, blocked fuel line, fuel system contamination, and air cleaner issues.
Engine Overheating
Troubleshoots issues related to carburetor adjustment, low engine oil, or operating RPM.
Excessive Vibration
Recommends checking for damaged turbine, loose parts, and tightening all hardware.
Unit Won't Pick Up
Addresses clogged discharge chute, foreign objects in the turbine, or a full cart.
Operating Your Trac-Vac
Pre-Operation Checks
Inspect the area, check hardware, and listen for unusual vibration before starting operation.
Vacuuming Techniques
Operate at recommended speed, avoid overloading the cart, and exercise caution on slopes.
Safety During Operation
Shut off engines for clogs, avoid passengers, do not tow on public roads, and avoid sudden turns.
Need help?
Do you have a question about the 880 and is the answer not in the manual?
Questions and answers