Nokia BH-607 User Manual page 11

To turn the lights back on, press and
hold the answer/end key, and slide and
hold the volume key up for about 5
seconds. The green indicator light
flashes once.
Allow connection to two
devices
You can have the headset connected
to two devices at the same time.
By default, the headset can only be
connected to one device at a time. To
allow the headset to connect to two
devices, switch off the headset, and
press and hold the power key, and
slide and hold the volume key up for
about 5 seconds. The green indicator
light flashes once.
To allow the headset to connect to
only one device, switch off the
headset, and press and hold the power
key, and slide and hold the volume key
down for about 5 seconds. The yellow
indicator light flashes once.
If the headset can connect to two
devices at the same time and you use
redialling or voice dialling, the call is
made on the device that you last used
to make a call when the headset was
connected to it.
Clear settings or reset
To clear all the settings from the
headset (including settings you have
defined with the Nokia Accessory
Setup Application), switch off the
headset, and press and hold the power
key and the answer/end key at the
same time for about 8 seconds. The
headset beeps twice, and the red and
green indicator lights alternate. After
the settings are cleared, the headset
enters pairing mode.
To reset the headset if it stops
functioning, even though it is charged,
connect the headset to a charger
while you press and hold the power
key.
ENGLISH