Contents 1 Important 7 Other features Safety Set the alarm timer Notice Set the sleep timer Declaration of conformity Listen to an external device Upgrade Firmware Trademarks Factory reset 2 Your Micro Music System What's in the box 8 Product information Overview of the main unit USB playability information Overview of the remote control...
Important Warning Never remove the casing of this apparatus. Never lubricate any part of this apparatus. Safety Never look into the laser beam inside this apparatus. Never place this apparatus on other electrical Read and understand all instructions equipment. before you use this micro music system. Keep this apparatus away from direct sunlight, If damage is caused by failure to follow naked �ames or heat.
Environmental information relevant provisions of Directive 2014/53/ All unnecessary packaging has been EU. You can �nd the Declaration of omitted. Conformity on www.philips.com/ Your system consists of materials support. which can be recycled and reused if disassembled by a specialized company.
Music System Congratulations on your purchase, The Auracast™ word mark and logos are and welcome to Philips! To fully trademarks owned by Bluetooth SIG, Inc. and bene�t from the support that Philips any use of such marks by MMD Hong Kong offers, register your product at...
Page 6
Quick start guide / Warranty card / Safety sheet Images, illustrations and drawings shown on this user manual are for reference only, actual product may vary in appearance.
Overview of the main unit LED indicator Disc compartment Standby indicator: turns red when this product is switched Open or close the disc to standby. compartment. Bluetooth/Auracast indicator: turns blue to indicate the Bluetooth/Auracast connection Start or pause play. status. Switch this product on or to Stop play.
Overview of the remote Skip to previous/next track. control Search within a track/disc. Tune to a radio station. Adjust time. SOURCE/BT PAIR Press to select a source: DlSC, BT, AURACAST, DAB, FM, USB, AUDIO IN. In Bluetooth mode, press and hold for more than 2 seconds to disconnect the currently connected device and enter...
Page 9
USB/AUDIO IN Tune to an FM station. Adjust time. Select USB source. Select a DAB+ station. Select AUDlO IN source. MODE /PAIRING Select shuffle mode to play Select Bluetooth source. tracks randomly. In Bluetooth mode, press and Select repeat mode to play a hold for more than 2 seconds track or all tracks repeatedly.
3 Get started Caution Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Connect speakers Connect the radio antenna Note Insert the stripped portion of each speaker...
Batteries contain chemical substances, so they should be disposed of properly. The Philips Entertainment App puts you in charge of the music you are listening To insert the remote control battery: to. You can use your smart device to Open the battery compartment.
4 Play Switch to standby mode Press again to switch the product to standby with no clock display, or to Play from disc standby with clock display. The red standby indicator lights up. Press CD to select CD source, or press In standby, you may press and hold source button on main unit to switch CLOCK to toggle clock display on...
Skip tracks For CD: Press to select tracks. For MP3 disc and USB: Press to select an album or a folder. Press to select a track or a �le. Program tracks This function allows you to program 20 tracks in the desired sequence. Control play In stop mode, press PROG/SCAN to activate the program mode.
Select 'Philips TAM3505M2'on Play from Bluetooth- your Bluetooth enabled device. enabled devices If you fail to �nd 'Philips TAM3505M2'or cannot pair with this product, press and Note hold BT PAlR on the product or PAlRING on the remote Compatibility with all Bluetooth devices is control for 2 seconds to enter not guaranteed.
Listen to the The micro system will automatically search for nearby Auracast radio broadcasts and connect to the unencrypted broadcast with the strongest signal. With this product, you can listen to DAB On your mobile device or dongle + radio and FM radio. that supports Auracast, follow the instruction to enable Auracast broadcast.
Press and hold PROG/SCAN for [PRUNE]: Remove invalid more than 2 seconds. stations from the station list. [SYSTEM]: Adiust system The product scans and settings. stores all DAB+ radio stations automatically. /OK. To select an option, press If sub-option is available, repeat After scan, the �rst available steps 2-3.
6 Adjust sound All available stations are programmed in the order of waveband reception strength. The �rst programmed The following operations are applicable radio station is broadcast to all supported media. automatically. Adjust volume level Store FM radio stations manually On the remote control, press Tune to an FM radio station.
7 Other features Activate/deactivate alarm timer In standby mode, press SLEEP/TIMER repeatedly to activate or deactivate Set the alarm timer timer. If timer is activated, TlMER is This product can be used as an alarm displayed. clock. You can select the disc, radio, or In standby, you may press and hold .mp3 �es on a USB storage device as CLOCK to toggle clock display on...
Download & Update. If the upgrade is released, the Download & Upgrade icon can be pressed to proceed automatically. Once this product is connected to Philips Entertainment app, it can receive over-the-air �rmware update. Always upgrade with the latest �rmware version to...
If you encounter problems when using this device, check the following points before requesting service. lf the problem Supported MP3 disc remains unsolved, go to the Philips Web formats page (www.philips.com/support). When you contact Philips, make sure that the device is nearby and the model number IS09660, Joliet and serial number are availaple.
Page 22
Remote control does not work Before you press any function button, frst select the correct source with the remote control instead of the main unit. Reduce the distance between the remote control and the unit. Insert the batteries with polarities (+/- signs) aligned as indicated.
Page 23
For some devices, the Bluetooth connection may be deactivated automatically as a power-saving feature. This does not indicate any malfunction of this unit. Timer does not work Set the clock correctly. Switch on the timer. Clock/timer setting erased Power has been interrupted or the power cord has been disconnected.
Page 24
Speci�cations are subject to change without notice. 2024 Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product.
Need help?
Do you have a question about the TAM3505M2 and is the answer not in the manual?
Questions and answers