Maple Systems HMI5043N Installation Manual

1
Introduction
Thank you for purchasing a Maple Systems HMI5000 Series graphic
operator interface terminal (OIT). The HMI5000 Series touchscreens are
configured using the EZware-5000 software
include the following models: HMI5043N/T, HMI5056N,
HMI5070NH/TH/ETH, HMI5100N/T, HMI5104TH, HMI5104XH,
HMI5121X, and HMI5150X. This booklet describes the steps necessary
for installing the HMI5000 Series touchscreens.
For information on programming and configuring the HMI, please refer
to the HMI5000 Series Programming Manual available on the EZware
software CD. For additional information, please refer to the Support
Center section on our website, www.maplesystems.com. The Support
Center provides links to manuals, FAQs, technical notes, training videos,
sample projects, controller information sheets, and controller cables.
Static Awareness
Do NOT remove the rear cover of your HMI5000 Series product – doing
so will void your warranty. When the rear cover is removed the circuitry
inside is exposed to possible damage by electrostatic discharge during
handling. Minimize the possibility of electrostatic discharge by:

Discharging personal static by grounding yourself prior to
handling the HMI.

Handling the HMI at a static-free grounded workstation.

Connecting the frame ground ( ) connector of the HMI to a
clean earth ground.

Placing the HMI in an antistatic bag during transport.
1010-1005 Rev 04
HMI5000 Series
Installation Guide
HMI5000 Series Installation Guide
(purchased separately) and
www.maplesystems.com