Dell OPTIPLEX FX160 Technical Manualbook page 18

DELL™ OPTIPLEX™ FX160 TECHNICAL GUIDEBOOK
OPTIMAL SYSTEM PLACE MENT (CONT.)
W A L L M O U N T
If the system is installed using the optional wall mount, ensure that none of the vents are
blocked on the system. The OptiPlex 160 has ventilation on four of the 6 surfaces. Space
the system so that there is adequate room for proper airflow, as defined by:
Top
Ensure there is at least 2 inches (50.8mm) between the top of the system and
the top of the ceiling, desk, or enclosure. This gap will allow heated air to exit the
system easily.
Bottom (surface that stand attaches to)
Ensure that there is at least 1 inch (25.4 mm) of clearance below the system.
This will allow room temperature air to enter the system for component cooling.
Right side (side opposite of mounting)
Ensure that there is at least 1 inch (25.4 mm) clearance for optimal system
cooling.
Left Side (surface that wall mount attaches to)
This gap is defined by the wall mount bracket.
18