Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fortinet FGR 70G-5G-D
Summarization of Contents
FG/FWF/FGR variants 5G features matrix
3G/4G/5G handover
Details how the 5G modem handles switching between 3G, 4G, and 5G networks based on signal strength.
LTE modem firmware upgrade
Explains upgrading the 5G modem firmware for enhanced compatibility or features using various transfer methods.
Scheduled 5G modem firmware upgrade
Allows setting up a recurring schedule for automatic firmware upgrades from FortiCloud server.
Automatic modem firmware switch
Describes how the modem automatically selects the appropriate carrier-specific firmware based on the SIM card.
Manual modem firmware selection
Enables manual selection of modem firmware, overriding the automatic carrier-based selection.
GPS location
Highlights the modem's GPS capability for location services, independent of the SIM card used.
Dual SIM card slots
Details the presence of two physical SIM slots, allowing simultaneous card holding for flexibility.
SIM card switch
Explains FortiOS's automatic selection of a valid SIM card and its monitoring for connectivity.
Dual SIM LEDs
Describes LED indicators on the front that show which SIM slot is currently active.
Installation
Antenna mapping
Illustrates the connection points for various external antennas on the device.
Hardware installation
Provides essential instructions and precautions before starting the physical installation of the device.
Check modem driver status
Details how to verify the status of the modem's drivers using specific commands.
Check modem status
Explains how to check the modem's operational status and detailed information via CLI commands.
Use 5G services
Guides on inserting the SIM card and enabling 5G services, including connection verification.
Configuration
Configure the modem from FortiGate GUI
Step-by-step guide to configure the 5G modem using the FortiGate graphical user interface.
Configure the modem from FortiGate Console
Instructions for configuring the 5G modem via the FortiGate command-line interface (CLI).
Connect your computer to FortiGate
Details on establishing a console connection from a computer to the FortiGate device for management.
Create a data plan
Explains how to define 5G modem data session settings and apply them to SIM slots.
Configure the modem
Provides detailed CLI commands for configuring various parameters of the built-in 5G modem.
set status
Command to enable or disable the 5G modem daemon, affecting data transfer capabilities.
set network-type
Configures the modem's network connection preference (e.g., auto, 4G/5G, 5G only).
set sim1-pin/sim2-pin
Commands to set the SIM card PIN for SIM slot 1 and SIM slot 2, if applicable.
set sim1-data-plan/sim2-data-plan
Applies defined data plan profiles to the SIM cards inserted in SIM slot 1 and SIM slot 2.
set carrier-config
Selects the appropriate modem firmware to pair with the inserted SIM card based on carrier.
set gps-service
Enables or disables the GPS service for the 5G modem.
Manage the modem
execute 5g-modem carrier-config list
Displays a list of available carrier configurations that can be used with the modem.
execute 5g-modem carrier-config switch xx
Switches the modem's carrier configuration based on the provided index for the SIM card.
execute 5g-modem cold-reboot
Powers the 5G modem off and then back on, performing a cold reboot cycle.
execute 5g-modem reboot
Performs a warm reboot of the internal 5G modem.
execute 5g-modem sim-switch
Switches the active SIM slot between SIM 1 and SIM 2.
Diagnose the modem
dia sys 5g-modem modem-details
Retrieves and displays detailed information about the 5G modem hardware and software.
dia sys 5g-modem sim-info
Shows the status and information for each SIM card slot, including ICCID and IMSI.
dia sys 5g-modem signal-info
Displays radio signal strength and band information for both LTE and 5G networks.
dia sys 5g-modem traffic-status
Shows data traffic statistics for the current data connection, including packets and bytes.
dia sys 5g-modem gps-info
Retrieves and displays GPS location information such as latitude, longitude, and time.
dia sys 5g-modem data-session-info
Provides information about the current active data session, including IP addresses and MTU.
Upgrade modem firmware
execute 5g-modem firmware-upgrade ftp [ImageFile] [FTP Server]:Port (username) (password)
Upgrades modem firmware using FTP, requiring server details, filename, username, and password.
execute 5g-modem firmware-upgrade tftp [ImageFile] [TFTP Server]
Upgrades modem firmware using TFTP, requiring server IP address and filename.
execute 5g-modem firmware-upgrade usb [ImageFile]
Upgrades modem firmware from a USB drive, specifying the firmware image file name.
execute 5g-modem firmware-upgrade management-station
Upgrades modem firmware from a management station, specifying the version ID.
Diagnostic test commands
Show modem status
Checks the current operational state of the 5G modem.
Show modem mode
Displays the current operating mode of the 5G modem (e.g., ONLINE).
Show modem connection status
Indicates the current connection status of the 5G modem.
Show SIM slot
Shows the status and ICCID of the SIM cards in both slots.
Show modem1 AT port
Displays the AT port information for modem 1.
Show modem GPS location
Retrieves and displays the GPS location information for the modem.
Show modem signal and band status
Shows radio signal strength, band, and other related parameters for the 5G modem.
Test modem warm reboot
Performs a warm reboot of the 5G modem.
Test modem sim switch
Tests the functionality of switching between SIM slots.
Test modem reset
Tests the modem reset function, bringing it offline and back online.
MIBs
Download MIB files
Instructions on how to download FortiGate and Fortinet Core MIB files for SNMP monitoring.
Enable SNMP support
Steps to enable the FortiGate as an SNMP agent and configure basic SNMP settings.
Create SNMP community
Guide to creating SNMPv1/v2c communities, specifying names, hosts, and access types.
Allow SNMP access
Ensures SNMP is enabled on the WAN interface for accessing MIB information remotely.
Configure MIB browser
Details on configuring a MIB browser to connect to the SNMP agent and retrieve MIB data.
Browse for MIB entries
Shows the path within a FortiGate device to browse for internal 5G modem MIB information.
Need help?
Do you have a question about the FGR 70G-5G-D and is the answer not in the manual?
Questions and answers