Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for SOLYCO R-WG 108n.4
Summarization of Contents
1. Introduction
Symbols used
Explains symbols for electrical shock, caution, and general notes.
2. General information
2.1 Regulations and standards
Lists applicable standards and local regulations for PV installations.
2.2 Disclaimer
States that information may be amended without notice and no guarantees are made.
2.3 Limitation of liability
Addresses liability for improper installation and refers to business/warranty terms.
2.4 General hazard information
Details risks of electric shock and electric arc, and essential safety precautions.
2.5 General warnings
Lists warnings to prevent product damage or harm to the environment.
2.6 General safety instructions
Provides safety guidelines for module installation location and operating conditions.
4. Mechanical installation
4.1 Mounting using suitable module clamps
Details clamp usage, screw requirements, and positioning for secure module mounting.
4.2 Mounting with screws
Explains using M8 screws, washers, and nuts for secure mounting at designated points.
4.3 Fastening with suitable laminate clamps
Covers requirements for laminate clamps and warranty implications.
4.4 Clamping ranges and permissible load capacities
Outlines test parameters for certification and load factors for mounting.
4.4.1 Securing via the inner mounting holes
Specifies compressive and suction load capacities for inner mounting hole configurations.
4.4.2 Securing via the outer mounting holes
Details load capacities when using outer mounting holes on the long side.
4.4.3 Clamping at four points on the long side of the module
Lists load capacities for clamping on the long side of the module.
4.4.4 Clamping at four points on the short side of the module
Provides load capacities for clamping on the short side of the module.
4.4.5 Clamping at the corners on the short side of the module
Specifies load capacities for corner clamping on the short side.
4.4.6 Long side installation – insert system
Details load capacities for insert system mounting on the long side.
4.4.7 Short side installation – insert system
Outlines load capacities for insert system mounting on the short side.
4.4.8 Mounting with four laminate clamps on the long side
Specifies load capacities for four laminate clamps on the long side.
5. Electrical installation
5.1 Interconnection
Covers rules for connecting modules in series or parallel, including voltage limits.
5.2 Earthing
Explains earthing requirements and options for modules, including frameless limitations.
5.3 Pre-activation inspection
Lists checks to perform before activating modules, such as insulation and wiring integrity.
Need help?
Do you have a question about the R-WG 108n.4 and is the answer not in the manual?
Questions and answers