Related Manuals for tufin T-1220
Summarization of Contents
Introduction
Overview
General overview of the T-Series appliance and the document's scope.
Shipping Container Contents
Details items found in the appliance's shipping box.
Contact Support
Information on how to reach Tufin support.
Appliance Hardware
Front View of the System
Identifies components on the appliance's front panel.
Rear View of the System
Identifies components on the appliance's rear panel.
Appliance Fans
Details specifications and airflow configuration for appliance fans.
Setting Up the T820/1220
Connect Your Appliance to the Network
Steps to connect the appliance to the network and perform initial setup.
Configuring Remote Access
Set up iDRAC
Instructions for configuring the Integrated Dell Remote Access Controller (iDRAC).
Monitor System Health
Accessing iDRAC to monitor system health and use the virtual console.
Configuring Link Redundancy
Configure Network Bond Interface
Steps to configure a network bond interface using nmtui.
Add Ports to Bond
Detailed steps for adding network interfaces as slaves to the bond.
Configure IP Address Settings
How to configure IPv4 settings for the bond interface.
Activate Bond Interface
Steps to activate the configured bond interface.
Verification
How to verify the link redundancy configuration.
Delete Network Bond Interface
Procedure for deleting a configured network bond interface.
Activate Network Interface
Steps to reactivate a network interface after bond deletion.
Installing and Configuring TOS Aurora
Network Requirements for TOS Aurora
Lists network prerequisites for TOS Aurora installation.
Configure the Appliance
Steps to reconfigure TufinOS for TOS Aurora.
Configure IP Address and DNS
Steps to configure IP/DNS for TOS Aurora.
Upgrade TufinOS
Information on upgrading TufinOS.
Upgrading TOS Aurora
Upgrade TOS Aurora
Instructions on upgrading TOS Aurora via Tufin Knowledge Center.
Updating BIOS and iDRAC Firmware
Single Node Setup
Steps for updating BIOS/iDRAC on a single appliance node.
Backup Your TOS Data
Procedure to create and manage TOS data backups.
Upgrade iDRAC
Instructions for performing an iDRAC firmware upgrade.
Upgrade BIOS
Instructions for performing a BIOS firmware upgrade.
High Availability Setup
Verify Appliance Version
Checks appliance version for HA setup.
Drain Non-Primary Node
Steps to drain a node before maintenance in an HA cluster.
Check Cluster Health
Verifies the health status of the k3s cluster.
Check TOS Status
Verifies TOS status and components in the cluster.
Node Maintenance Preparation
Prepares a node for maintenance by draining it.
Upgrade iDRAC
Instructions for upgrading iDRAC on HA nodes.
Upgrade BIOS
Instructions for upgrading BIOS on HA nodes.
Restore Node to Cluster
Steps to restore a node to the cluster after maintenance.
Transfer Primary Role
Steps to transfer the primary role to an updated data node.
Restoring Factory Defaults
Restore Default Settings
Steps to restore the appliance to its factory default settings.
Download and Install TOS
Procedure to download and install TOS after restoring defaults.
Deleting Your Data
Delete Appliance Data
Commands to securely delete all data from the appliance.
Need help?
Do you have a question about the T-1220 and is the answer not in the manual?
Questions and answers