4. Within the
Menu
column of main interface, use the arrow key to highlight
the
Select Disk Drives
activated, see below:
Just highlight the target disks that you want to use and press ENTER to
select them respectively; After all disks have been selected, press ESC to go
back to the creation steps menu;
5. If user selected a RAID 0 or 0+1 array in step 2, then now, user needs to
select a block size for the array. Within the
use the arrow key to highlight the
block size from the popup list, see below;
6. Within the
Menu
column of main interface, use the arrow key to highlight
the
Start Creation Process
will appear, see below:
Please pay attention to the warning message, and then press Y to finish the
creation, or press N to cancel the creation.
(The warning message may be different depending on what array mode that user is
creating)
2-3
and press ENTER, the
Status
Menu
Block Size
and press ENTER, then select a
and press ENTER, then some warning messages
BIOS Configuration Utility
column will be
column of main interface,