AIRMASTER 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL: (02) 9313 7111 FAX: (02) 9313 7555 www.palsonic.com.au AIRMASTER CUSTOMER SERVICE TELEPHONE AUSTRALIA: 1300 657 888 Thank you for purchasing our air-conditioner. Please read this owner's manual carefully before using your air conditioner.
How to Use NAMES OF THE PARTS Front Cover Air inlet grille (Indoor) Cabinet Air outlet grille (Indoor) Air inlet grille (Outdoor) Vent Lever Control Panel (Show in page 4) Cover Control Panel (behind panel cover) Spice box (Used in some type of air conditioner Air filter Fig: 1...
Page 3
CONTROLS NAMES The panel of 7000~9000Btu/h The panel of ON/OFF 12000Btu/h Cooler HIGH COOL LOW COOL LOW FAN The panel of HIGH FAN ON/OFF SELECTOR THERMOSTAT Cooler 18000~24000Btu/h WAIT FOR THREE MINUTES BEFORE RESTARTING HIGH COOL COOL HIGH THERMOSTAT SELECTOR THERMOSTAT SELECTOR WAIT FOR THREE MINUTES BEFORE RESTARTING...
Page 4
THERMOSTAT The temperature gets lower from 1 to 5 is for cooling function. CAUTION The compressor operates continuously by setting the temperature dial to nearly "TEST". Do not set this dial to the setting as it is for testing purpose. When the compressor stops by turning the temperature dial in cooling operation, wait 3 minutes before turning it back to restart the compressor.
Names and Functions of remote controller (ONLY APPLICABLE FOR REMOTE CONTROL TYPE) Mode display: Mode selection key Cool - Dry - Fan Setting for increasing of temperature Set Temperature Display Setting for decreasing of temperature Fan speed display Fan speed setting HI - LOW up key Vane setting key...
AIR FILTER The air filter should be washed at least once every 20 days. If the air filter remains full of dust, the air flow will decrease and the cooling capacity will be reduced. The filter is behind the cover and to be pulled out from right hand side. Wash the air filter with water an detergent.
Never use hot water above 50 C, benzene, gasoline, acid, thinner or brush to wipe off dirt because they will damage the plastic surface and the coating. LONG OFF PERIOD MAINTENANCE Operate the fan alone ("LOW FAN "or "HIGH FAN") for half a day to dry out the inside of the unit.
Installation Instruction REMOVE ALL THE SHIPPING PARTS BEFORE INSTALLATION LOCATION Select a location that can support the weight of the air conditioner and one that will not cause increased operation noise and vibration. Direct sunlight is unfavourable for efficient cooling. Select a place where there is no obstacles near the air inlet and outlet.
CAUTION The installation parts must be strong against corrosion, especially in case the air conditioner will be installed near the sea or hot spring. Do not install air conditioner in the place where inflammable gas leaks are a possibility. OPERATION Check the capacity of wiring and power outlet.
Page 10
1) Remove the front panel (Fig. 6) Remove the air filter. (Fig. 7) Remove screw at the bottom of the front panel. (Fig. 8) Fig.6 Open the panel cover. 2) Remove the screw and retaining bracket from the front of the cabinet. (Fig. 9) 3) Remove the 2 screws from the lower rear side of the cabinet.
Page 12
Unit, It will not be held responsible for only breakdown if this unit is not installed properly, AIRMASTER 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL: (02) 9313 7111 FAX: (02) 9313 7555 www.palsonic.com.au AIRMASTER CUSTOMER SERVICE TELEPHONE AUSTRALIA: 1300 657 888 AAC70CW AAC90CW...
Need help?
Do you have a question about the AAC90CW and is the answer not in the manual?
Questions and answers