Congratulations on your purchase of the CW600.T heart rate monitor. Passionate and regular participants of an endurance sport, the CW600.T will allow you to optimize the effectiveness of your training. With its target range indicator, its passing alarm and automatic summary, target desired...
• Please read guidelines carefully before use. Retain these guidelines for as long as you have the watch. • Do not manipulate the buttons under water, and do not go beyond the depth indicated by the following table with the watch. •...
Installation procedure 1 Wet the sensors with water or a water-based conducting gel to ensure 2 Introduce one rib of the elastic into one of the holes on the belt good contact. 3 Attach the belt around the chest, then position provided for this purpose.
Page 6
1 - Time mode (TIME): 17:24 S1 : activation / deactivation of chimes S4 : settings mode (press and hold S2 : date display S3 : Go to cardio mode for 3 seconds) S5 : Electroluminescence Setting of the time, date and 12/24h mode : •...
Setting parameters : 1013 Before anything else, you must enter your personal parameters so that the device can provide you with the most personally accurate measurements possible.. After you have entered the heart rate monitor mode (PULS) by pressing successively on the S3 button as indicated in paragraph 6.
1013 Fig. b Fig. a In the "cardio" function, if the heart rate displayed is higher than the upper limit of the target zone, the display indicates this with the following symbol (fig a.). If it is 22:01 lower than the lower limit, the symbol displayed is the one in figure b. If the passing alarm is activated (ON), the watch will emit 1 beep every 6 seconds if your heart rate is LOWER than the Target Zone.
Page 9
ATTENTION : No measure of heart rate when the electroluminescence function is activated or the alarm sounds. The stopwatch function 12:30 In stopwatch mode (CHRONO) : Press S1 to start the stopwatch. Press S2 to stop the stopwatch. Press S4 when the stopwatch has stopped to reset it to 0. 1013 Intermediate time In stopwatch mode :...
Set the minutes with S1 or S2. Once the correct hour is indicated, press S4 to exit the settings mode. Activation of the day alarm In the Alarm Mode, press S1 or S2 to activate/deactivate the alarm. When the alarm is activated, a graphic flashes at the bottom of the screen (see drawing, paragraph 1).
Batteries : The battery used in the chest belt is a CR 2032. Watch : The battery used in the watch is a CR 2032. We recommend that you not change the watch batteries yourself, but rather have the job done by a specialized DECATHLON repair shop. If you change the battery yourself, you may damage the seal and lose both the water tightness and guarantee on the product.
Page 12
Problem Cause 1 – Heart rate is not 1.1 – The electrodes are not moistened enough. displayed. 1.2 – The belt is incorrectly positioned. 1.3 – Belt battery low or flat. 2 – Watch display is faint 2.1 – HRM watch battery is low. or illegible.
Operation / Procedure Moisten the electrodes using conducting aqueous gel or water. Check the positioning of the belt around your chest: it should be positioned as shown in the instruction leaflet. Bring the HRM watch and the belt closer together, check the above points, and then check transmission.
Page 14
Principles of training For reasons of effectiveness and safety, it is indispensable for you to know certain physiological parameters required for training. The advice that we provide here is intended for healthy, active persons who do not present any pathology. We strongly advise you to obtain the advice of your physician in order to establish your most precise training zone.
Page 15
Contact As we strive to continually improve the products we develop, we are interested in your feedback regarding the quality, the functionality and the usage of our products. • In France, please call the customer service center at: 0810 08 08 08 (local call rate) •...
Need help?
Do you have a question about the HEART RATE MONITOR CW600T and is the answer not in the manual?
Questions and answers