Desa PG15EA Service Manual

Outdoor electric patio table umbrella stand and foot warmer
Hide thumbs Also See for PG15EA:

Advertisement

Quick Links

OUTDOOR ELECTRIC PATIO TABLE UMBRELLA STAND AND
MODELS PD15EA, PG15EA, PL15EA AND PV15EA
IMPORTANT: Read and understand this manual
before assembling, starting or servicing this
product. When using electrical products, basic
safety precautions should always be followed to
reduce the risk of fire, electric shock and injury to
persons. Keep this manual for future reference.
Safety Information ............................................... 2
Pre-Operating Instructions .................................. 3
General Information ............................................. 4
Product Identification ........................................... 5
Installation ........................................................... 5
Operation ............................................................. 5
Cleaning .............................................................. 5
FOOT WARMER SERVICE MANUAL
1500 WATT 120V 60HZ 12.5 AMPS

TABLE OF CONTENTS

Save this manual for future reference.
For more information, visit www.desatech.com
Wiring Diagram .................................................... 5
Safety Requirements ........................................... 6
Cautions .............................................................. 6
All Systems Working Together ............................. 6
Troubleshooting ................................................... 6
Reassembly Points .............................................. 8
Illustrated Parts Breakdown and Parts List ....... 10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PG15EA and is the answer not in the manual?

Questions and answers

Summary of Contents for Desa PG15EA

  • Page 1: Table Of Contents

    OUTDOOR ELECTRIC PATIO TABLE UMBRELLA STAND AND FOOT WARMER SERVICE MANUAL MODELS PD15EA, PG15EA, PL15EA AND PV15EA 1500 WATT 120V 60HZ 12.5 AMPS IMPORTANT: Read and understand this manual before assembling, starting or servicing this product. When using electrical products, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to...
  • Page 2: Safety Information

    SAFETY INFORMATION IMPORTANT: Read this manual carefully and completely before trying to assemble, operate or service this product. When using electrical products, the following basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons.
  • Page 3: Pre-Operating Instructions

    SAFETY INFORMATION Continued 29. Use only in accordance with the local ordi- nances and codes. 30. This product is not to be used as the sole support for an umbrella. Umbrella must be supported by a table. 31. Do not use or install umbrella into product at temperatures below freezing.
  • Page 4: General Information

    ARRANGEMENT OF MANUAL This manual contains information and service procedures to assist the service technician in understanding and correcting problems on DESA Heating Products Umbrella Stand and Electric Foot Warmer. The first section of the manual contains basic information concerning the op- eration of the different components in the heater.
  • Page 5: Installation

    INSTALLATION 1. Locate product under outdoor patio table on hard, level, dry surface. Post of tip over switch must be on solid surface for product to work. Listen for the “click”. See Figure 3 for switch location. 2. Slowly lower umbrella pole into product. Do not drop pole, it may damage product.
  • Page 6: Troubleshooting

    CAUTIONS 1. Before servicing, disconnect the heater from the electrical power source by removing the electrical plug from the wall receptacle. Note: When certain tests require electrical power to be applied, connect electrical power only for the time necessary to complete the test. 2.
  • Page 7: Troubleshooting

    TROUBLESHOOTING Continued 7. Replace removed plug in hole. Perform a trial operation. 8. If repeated resetting of the thermal limit switch is required, have the product serviced by an authorized service center. OBSERVED FAULT Tubular heating element heats up but no rush of warm air is felt at outlet vents Rotate fan by hand to determine if fan rotates easily...
  • Page 8: Reassembly Points

    REASSEMBLY POINTS Because this is an outdoor product where the control of water is important, the following steps for assembly must be followed. 1. The closed cell foam gasket must seal the hex shaped pan to the inside of the plastic housing (see Figure 8).
  • Page 9 REASSEMBLY POINTS Continued 7. Tubular heating element must be flush against bracket (see Figure 14). This centers the ele- ment to the center hole in metal pan. 8. Fan must be located with set screw at back of and on flat of shaft (see Figure 15). 9.
  • Page 10: Illustrated Parts Breakdown

    ILLUSTRATED PARTS BREAKDOWN Requires Loctite Thread Locker Blue www.desatech.com Brass Washer Rubber Seal Bottom View Steel 115423-01A...
  • Page 11: Parts List

    This list contains replaceable parts used in your product. When ordering parts, be sure to provide the correct model and serial numbers (from the identification decal), then the part number and description of the desired part. PART NUMBER 113560-01 M11084-39 113053-01 113152-01 113570-01...
  • Page 12 2701 Industrial Drive P.O. Box 90004 Bowling Green, KY 42102-9004 www.desatech.com 115423 01 NOT A UPC 115423-01 Rev. A 10/04...

This manual is also suitable for:

Pl15eaPv15eaPd15ea

Table of Contents

Save PDF