Related Manuals for Ropox 4Single 50-47026
Summary of Contents for Ropox 4Single 50-47026
- Page 1 4Single Battery User manual This manual must always accompany the product TF 200.02.0040 / Date 22-05-2023 TF 200.02.0040_ENG...
-
Page 2: Table Of Contents
Table of Contents Symbols used in this manual ........................3 General safety ............................3 General requirements ..........................5 Product information ........................5 Product description ........................5 Intended use ..........................5 Intended population ........................6 Intended operator ........................6 Basic safety ..........................6 Charging the battery .......................... -
Page 3: Symbols Used In This Manual
Symbols used in this manual Warning Symbol Indication of potentially hazardous situation. If not avoided, it can result in serious injury or death. Caution Symbol Indication of potentially hazardous situation which may result in minor or moderate injury. It may also be used to alert against unsafe practices. Notice Symbol This symbol is used to notify correct use and handling of the product. - Page 4 The information in this manual is based on correct installation in accordance with installation instructions for this product. Ropox cannot be held liable if the product is used in any way, that differs from stated in this manual and/or installation instruction.
-
Page 5: General Requirements
General requirements Product information Ropox A/S Ringstedgade 221, DK-4700 Naestved Manufacturer +45 55 75 05 00 E-mail: Info@ropox.com Part number Model Stroke length Product models 50-47025 Rapid stroke 300 mm / 11.8 in 50-47026 Heavy load 300 mm / 11.8 in 150kg / 330 lbs. -
Page 6: Intended Population
Intended population Anyone who can find use in having a tabletop or workstation with an adjustable height. Intended operator Anyone who has read and understood this manual can use the product. However, children over the age of 8 may only use the product under the supervision of an adult. Basic safety A 4Single Frame can be bought with a safety-strip, which must be mounted on the fascias. -
Page 7: Recharging Procedure
Recharging procedure a) Unplug the battery from the docking bay. b) Plug the charger into the battery. Check to see if the LEDs are on. If the next LED starts to flash, the battery is recharging. c) Wait 3½-4½ hours until all the 4 LEDs are on without flashing. If you have any doubts whether the battery is fully charged, and 4 LEDs are on, unplug the charger. -
Page 8: Mounting Instructions
Mounting instructions Page | 8 TF 200.02.0040_ENG... - Page 9 Page | 9 TF 200.02.0040_ENG...
-
Page 10: Electrical Component Diagram
Electrical component diagram The included cables must be mounted in accordance with the following diagram. The safety strip can only be mounted if it has been chosen as an accessory. Otherwise, the control can be mounted directly in the control box. Mounting the control a) Pull cable through hole in fascia and connect the control, via the control cable, to the control box b) Carefully remove the protection paper, on the back of the press pad, while keeping your finger... -
Page 11: Testing
Testing After mounting the battery on the 4Single Frame, and before putting it into use, the frame must be tested to ensure that it functions properly, and that the safety is upheld. Afterwards, it is recommended to test the function of the 4Single Frame at least once a year, by qualified personnel. -
Page 12: Troubleshooting
Troubleshooting ➢ Check the battery status. If the battery status drops below 25%, It is recommended to recharge the battery. ➢ Make sure the cables are connected correctly between the control box The frame cannot be and the motors height adjusted ➢... -
Page 13: Maintenance
➢ Discharge the battery fully, then recharge it to full charge. This extends the lifetime of the battery Component part list Notice! Ropox will make part lists available for extraordinary maintenance and repair beyond what is described in this manual. Repair beyond what is described in this manual may only be done by Ropox designated service personnel. -
Page 14: Accessories, Component Part List
1x Docking bay 96000826 1x Charger 96000827 96000828 (EU plug) 1x Mount for control box and battery 97701-851 4x Screw ø4.2x6.5 95090806 1x Control – 6x3cm 30-67840 1x Adapter Cable control to battery 96000824 2x Adapter cable motor 96000557 Accessories, component part list 1x Connection –... -
Page 15: Environmental Protection
Environmental protection The equipment must be disposed of in accordance with national legislation. It’s recommended to dismantle the product as much as possible before disposal. Never attempt to dismantle the battery. 10.1 Packaging, transport, and storage The battery must be packaged and transported according to the current regulations for lithium-ion batteries. These are also applicable when the product is re-packaged in case of a return delivery.
Need help?
Do you have a question about the 4Single 50-47026 and is the answer not in the manual?
Questions and answers