Advertisement
Advertisement
Related Manuals for SetPower PT55
Summary of Contents for SetPower PT55
- Page 1 User Manual V1.0...
-
Page 3: Table Of Contents
CONTENT 1.SAFETY INSTRUCTIONS 2.DATA SHEET 3.OVERVIEW 4.USE REMINDERS 5.OPERATING INSTRUCTIONS 6.TROUBLE SHOOTING 7.WARRANTY... -
Page 4: Safety Instructions
1.SAFETY INSTRUCTIONS Please read the user manual and safety instructions carefully before using the appliance. 1.1 Disclaimer The manufacturer cannot be held responsible for the damage resulting from improper usage or incorrect operation. The use of accessories that are not recommended by manufacturer can cause injuries and will invalidate any warranty that you may have. - Page 5 Please use non-abrasive detergent to cleaning the interior/exterior of the fridge. Please don't scrap the interior of the fridge to defrost/de-ice the fridge. Please don't pressure-wash/spray the fridge with a running water hose. 1.4 Dos and Don’ts Do not expose the unit to moderate/heavy rain. Do not use this appliance near direct heat sources, such as flame or radiator.
- Page 6 1.5 INTENDED TO USE This appliance is intended to be used in household and similar applications such as: Staf f kitchen areas in shops, of fices and other working environments; Farm houses and hotels, motels and other residential type environments; Bed and meal environments;...
-
Page 7: Overview
2.SPECIFICATIONS PT35 PT45 PT55 Model External 24.4×15.8×17.1 inches 34.6×18.9×18.2 inches 34.6×18.9×18.2 inches Dimensions (620×400×435mm) (620×400×505mm) (620×400×575mm) (L*W*H) Capacity 37 Qt / 35 L 47.6 Qt / 45L 58.1 Qt / 55L Net Weight 38 lbs (17.3 kg) 42 lbs (19.1kg) 44 lbs (20.1kg) - Page 8 37Qt (35L) FRIDGE 47.6Qt (45L) FRIDGE 58.1Qt (55L) FRIDGE...
-
Page 9: Use Reminders
4. USE REMINDERS Some Reminders 1. If the device was not placed in the upright position after transit and delivery, please keep it upright for 24 hours to make sure that the compressor can work properly. 2. If the device can’t turn on or you encounter other problems for first time use, please contact us for help. - Page 10 5.1 HOW TO USE THE REFRIGERATOR 5.1.1 Connecting with 12V or 24V Connect the feeding cable to a direct current 24V DC power source. ● Make sure the polarity is right. ● If connected to an existing cigarette plug, please carefully check up that power supply is sufficient.
- Page 11 5.2 Operation ● TURN ON OR TURN OFF THE FRIDGE: when the fridge turn on, press and hold the " " button for 2 seconds to enter the standby state. In the standby state, press and hold the " " button for 2 seconds to turn on.
- Page 12 ● SWITCH MAX OR ECO MODE: under the fridge turn on condition, press and hold the " " button in the COMPRESSOR SPEED area, to switch MAX or ECO mode. ECO mode is defaulted. ● SWITCH SINGLE OR DUAL ZONE: when the dual zone at work, press and hold "...
- Page 13 5.3 BATTERY PROTECTION FUNCTION Under the startup state, press " " button at BATTERY PROTECTION zone to enter the battery protection function, then choose HIGH/MID/LOW, the corresponding indicator shows the battery protection settings. H is defaulted by factory. Input voltage protection recovery protection...
-
Page 14: Troubleshooting
6.TROUBLESHOOTING 6.1 POWER CUTTING IN/OUT ● Your fridge has built in battery protection and needs a minimum 10.9V to start and 9.6V to continue operating. ● During operation a load is placed on the circuit and power supply and the voltage can drop by as much as 2V, many things can affect voltage drop, such as: increased resistance from long cables, or cables that are undersized or oversized for the application. - Page 15 6.2 COMMON 12V POWER SUPPLY ISSUES Wiring The standard wiring from the car battery to the 12V outlet may not be rated to power the fridge. Ensure the wire gauge is of sufficient size to supply the fridge’s current draw over the length required. If unsure, check with the vehicles instruction manual or, contact a local automotive electrician for advice.
- Page 16 6.3 ERROR CODES & SOLUTIONS When the refrigerator fails, the digital screen displays the failure mode, as shown in the following table: CADE Error Type Action Battery voltage low protection Check battery voltage (Module input voltage is lower than and adjust Low Voltage the set value).
-
Page 17: Warranty
If a single zone reports NTC failure, which means this zone stops working, and the other zone can still be normally refrigerated; When both zones report NTC failure, which means the compressor stops working. 7.WARRANTY & RETURN 7.1 Warranty 3-year Warranty for The Compressor 1-year General Warranty For Warranty Registration, please contact us for more information. - Page 18 Note: Videos or photos is preferred, because they can help us find out the reason causing the issue and improve the efficiency of solving problems. If calling the customer service number out of working time, you can leave a voice/text message. We will respond to you after getting back to work.
- Page 19 After the package is delivered back to our warehouse, a full refund will be initiated. If you file a return request on Amazon, we will process it in 48 hours and contact you via Amazon Message Service, please pay attention to your Amazon Message Box or Email in order to avoid missing important notifications.
- Page 20 OUR GUARANTEE SetPower product comes with a 3-year warranty on the compressor and 1 year warranty on all other parts for your peace of mind. In the unlikely event this product fails when used according to our user guide, we will either repair or replace it. For full warranty terms and conditions on this product, please see the user guide.
Need help?
Do you have a question about the PT55 and is the answer not in the manual?
Questions and answers