Biostar TA790GX 128M Setup Manual page 35

Notices:
Not all types of AMD CPU perform above overclock setting ideally; the difference will be based on the
selected CPU model.
B. Memory Integration Test (M.I.T.)
This function is under "Overclocking Navigator Engine" item.
MIT allows users to test memory compatibilities, and no extra devices or
software are needed.
Step 1
The default setting under this item is "Disabled"; the condition parameter should
be changed to "Enable" to proceed this test.
Main Advanced
T-Series Settings
WARNING: Setting wrong values in below sections
may cause system to malfunction.
OverClock Navigator
=========== Automate OverClock System ===========
Auto OverClock System
============ Manual OverClock System ============
CPU Over Voltage
Memory Over Voltage
Chipset Over Voltage
HT Over Voltage
CPU Frequency
> CPU FID/VID Control
> DRAM Timing Configuration
> Hyper Transport Configuration
> Memory Configuration
Integrated Memory Test
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Main Advanced
T-Series Settings
WARNING: Setting wrong values in below sections
may cause system to malfunction.
OverClock Navigator
=========== Automate OverClock System ===========
Auto OverClock System
============ Manual OverClock System ============
CPU Over Voltage
Memory Over Voltage
Chipset Over Voltage
HT Over Voltage
CPU Frequency
> CPU FID/VID Control
> DRAM Timing Configuration
> Hyper Transport Configuration
> Memory Configuration
Integrated Memory Test
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Step 2
Save and Exit from CMOS setup and reboot the system to activate this test.
Run this test for 5 minutes (minimum) to ensure the memory stability.
Step 3
When the process is done, change the setting back from "Enable" to "Disable"
to complete the test.
TA790GX A2+/TA790GX A2+ SE/TA790GX 128M
BIOS SETUP UTILITY
PCIPnP Boot Chipset
[Normal]
[V6-Tech Engine]
[StartUp]
[1.95V]
[1.15V]
[1.20V]
[200]
[Disabled]
↓
BIOS SETUP UTILITY
PCIPnP Boot Chipset
[Normal]
[V6-Tech Engine]
[StartUp]
[1.95V]
[1.15V]
[1.20V]
[200]
[Enabled]
T-Series Exit
Options
Enabled
Disabled
Select Screen
Select Item
+- Change Option
F1
General Help
F10 Save and Exit
ESC Exit
T-Series Exit
Options
Enabled
Disabled
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
33