Desa Comfort Glow CF26NR Owner's Operation And Installation Manual page 11

INSTALLATION
Continued
10. Install the switch plate on the blower control shield with 2 -
#10 screws provided (see Figure 16). Route power cord out of
the cabinet by inserting it through the bushing on the outer
casing (see Figure 15). Plug fan kit into 120-Volt grounded
power supply and test operation. Note: When switch is in the
AUTO position, the fan will start after the heater has run for a
few moments. The fan will continue to run for several mo-
ments after the heater has been turned off. When switch is in
the ON position, the fan will run until turned to OFF. Reinstall
hood assembly and close lower louver door.
11. Place log set back on the unit.
Blower Bracket
Assembly
Screw
Switch
Wire Harness
Power
Cord
Red
Blue
Switch Plate
Wire
Harness
Blower
Control
Shield
Shield Cover
Figure 15 - Installing Blower Bracket Assembly
Blower
Control Shield
Switch Plate
Screw
Figure 16 - Installing Switch Plate to Blower Control Shield
For more information, visit www.desatech.com
For more information, visit www.desatech.com
105443-01E
For Built-In Installation
the wiring harness to electrical supply following all
local codes. Electrician must provide a clamp on the
box cover to secure the wiring. Wiring should be
routed through the bushing in the hole on the outer
casing of heater.
Wiring
TIONS This appliance is equipped with a three-prong
Routing Hole
(grounding) plug for your protection against shock
hazard and should be plugged directly into a properly
Heat
grounded three-prong receptacle.
Deflector
1. Install a snap bushing found in hardware kit into one of the
2.
3. Remove black plastic strain relief and power cord from switch
Screw
Switch
Switch
Plate
Figure 17 - Installing Blower Bracket Assembly
Installing Blower Assembly - GA3450T (Cont.)
WARNING: A licensed electrician must connect
WARNING: ELECTRICAL GROUNDING INSTRUC-
holes found on rear of blower control shield. The other hole is
for a strain relief clamp (not supplied) to secure incoming elec-
trical supply.
Follow steps 2 through 6 in Installing Blower Assembly, page
10. Also remove black wire from middle/OFF switch terminal.
plate (see Figure 17). The power cord supplied will not be used
in built-in installations. Pop in the plastic snap bushing found
in hardware kit into the hole left by supply cord/strain relief.
Blower Bracket
Assembly
Strain
Wire
Relief
Harness
Power
Cord
Outlet
Blue
Red Receptacle
Shield
Cover
Blower
Control
Shield
Clamp
Connector
(not included)
INSTALLATION
11
11
Wire
Harness