Advertisement
Quick Links
This replacement procedure can be used for:
AUDI A4 B5 Saloon (8D2) 1.6, AUDI A4 B5 Avant (8D5) 1.6
The steps may slightly vary depending on the car design.
WWW.AUTODOC.CO.UK
How to change front wheel bearing
on
Audi A4 B5 saloon
guide
VIDEO TUTORIAL
Important!
– replacement
1–35
Advertisement
Related Manuals for Audi 8D2
Summarization of Contents
Audi A4 B5 Saloon Wheel Bearing Replacement Guide
Important Model Compatibility
Procedure applicable to Audi A4 B5 Saloon (8D2) 1.6 and (8D5) 1.6 models.
Step-by-Step Wheel Bearing Replacement
Initial Preparation and Bolt Loosening
Open bonnet, secure vehicle with chocks, and loosen driveshaft and wheel bolts.
Disassembly of Wheel and Brake Components
Remove wheel, caliper, bracket, disc, and driveshaft fastener.
Suspension and Driveshaft Detachment
Support knuckle, detach control arms, and separate driveshaft.
Hub and Bearing Extraction and Cleaning
Remove hub, extract old bearing, clean hub and seat.
New Bearing Installation and Hub Reassembly
Install new bearing, fit hub, and secure with bolt.
Reassembly of Suspension and Drivetrain
Reinstall control arms, driveshaft, and tighten fasteners.
Brake System and Wheel Reinstallation
Reassemble brake caliper, install disc, mount wheel, and torque bolts.
Final Lowering and System Checks
Lower vehicle, check brake pedal, and secure fluid cap.
AUTODOC Expert Recommendations for Wheel Bearing Replacement
General Safety and Procedure Best Practices
Ensure engine is off, avoid injury, handle components safely, and follow instructions.
Brake System and Fluid Handling Tips
Secure caliper, avoid pedal actuation, and manage brake fluid levels.
Component Installation and Torque Specification Guidance
Ensure correct bearing seating and tighten fasteners to specified torque.
Vehicle Support and Final Tightening
Support vehicle properly, lower gently, and hold wheel during tightening.
Need help?
Do you have a question about the 8D2 and is the answer not in the manual?
Questions and answers