Advertisement
Operating Instructions:
All work modes and parameters can be set up by a combination with Infrared remote control operation.
1. Before operation, make sure the batteries(3V, CR2025) have been installed properly.
2. Operation Instructions
There are 8 dedicated color brightness pushbuttons(marked Red, Green, Blue, White,
Cyan, Magenta, Yellow, Amber). There are also the "AUTO" and the "UNIT SETTING"
pushbuttons, as well as Raise&Lower keys(marked
on the remote unit.
For further information, please refer to the following table;
Pushbuttons&Keys
RED pushbutton
GREEN pushbutton
BLUE pushbutton
CYAN pushbutton
MAGENTA pushbutton
YELLOW pushbutton
WHITE pushbutton
AMBER pushbutton
AUTO pushbutton
PATTERN/RED key
PATTERN/RED key
SPEED/GREEN key
SPEED/GREEN key
FADE/BLUE key
FADE/BLUE key
BRIGHTNESS key
BRIGHTNESS key
UNIT SETTING pushbutton
for "raise" and
Red, 100% brightness
Green, 100% brightness
Blue, 100% brightness
Cyan, 100% brightness
Magenta, 100% brightness
Yellow, 100% brightness
White, 100% brightness
Amber, 100% brightness
The color is changing automatically, and the brightness is 100%.
To select the next pattern or increase the red brightness, and holding it down,
the brightness will increase continuously until up to the maximum.
To select the previous pattern or decrease the red brightness, and holding it down,
the brightness will increase continuously until up to the minimum.
To increase the speed or the green brightness, and holding it down, it will
increase continuously until up to the maximum.
To decrease the speed or the green brightness, and holding it down, it will
increase continuously until up to the minimum.
To increase the fade time or the blue brightness, and holding it down, it will
increase continuously until up to the maximum.
To decrease the fade time or the blue brightness, and holding it down, it will
decrease continuously until up to the minimum.
To increase the overall brightness, and holding it down, it will increase
continuously until up to the maximum.
To decrease the overall brightness, and holding it down, it will increase
continuously until up to the minimum.
1. DMX address is set ''1" by default, and with 24 DMX Channels in total.
The Red effect is controlled by Ch1,
The Green effect is controlled by Ch2,
The Blue effect is controlled by Ch3.
2. In Master-Slave operation, one unit will act as the Master unit and the
others will act as the Slave units after Daisy chain your units via the
XLR connector.
3. The Brightness is 100%.
-Page 2-
for "lower")
Functions
Remote Control
Advertisement
