Table of Contents
Advertisement
5. At the cable entry point, take care that the grooves in gaskets A and B are opposite each
other (see the figure). Tighten the locking nuts to hold the scanner cable firmly in place and
to provide a waterproof seal.
6. Place the internal locking nut over the end of the scanner cable in the order shown, then
attach the three connectors on the interconnection cable to the three J connectors (as
shown at F in the figure):
7. Tighten the strain relief clamp then connect Connector end E to one of the screws close by
to provide an Earth.
The wiring details for the connector ends (B, C, D, and E) are as follows:
18
Connector end B to J302
Connector end C to J202
Connector end D to J201
Northstar 4 kW Radar Installation Manual
Advertisement
Table of Contents
