Table of Contents
Advertisement
Setup steering angle sensor
This screen guides the installation and calibration of a steering
angle sensor. Three items may be displayed on the screen (the
second and third items are displayed only if the first is set to
Yes):
• whether or not the sensor is installed (Yes or No)
• the sensor polarity (Normal or Inverted)
• the sensor's range (35°, 45° or 60°)
Use the cursor pad to select an item above, then press Edit to
allow changes to the item. Use the cursor pad to select the new
value, and press ENTER to save the new value.
To calibrate the sensor, press Calibrate, center the rudder or
wheel, and press ENTER.
Setup trim
This screen guides the installation and calibration of the vessel's
engine trim. Three items may be displayed on the screen (the
second and third items are displayed only if the first is set to
Yes):
• whether or not a trim sensor is installed
• whether or not a popup gauge should be displayed for 10 sec-
onds whenever the trim changes
• the popup filter setting, designating how much trim change is
needed to cause the popup display
The gauge dial displays the operating range of the trim setting as
readings from 0 to 10, covering 2/3 of the dial. The remaining
third of the dial indicates the trailer positions of the trim (read-
ings from 10 to 25).
GMSMCRFT Rev A
– 17 –
Advertisement
Table of Contents
