Table of Contents
Advertisement
OPERATING FIREPLACE
24
For Your Safety Read Before Lighting
Lighting Instructions
To Turn Off Gas To Appliance
Optional Remote Operation
OPERATING FIREPLACE
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This a ppliance is equipped with an ignition de vice w hic h
automatically lights the pilot. Do not try to light the pilot
by hand.
B. BEFORE LIGHTING smell all ar ound the a ppliance ar ea
for gas. Be sur e to smell ne xt to the f loor because some g as
is hea vier than air and will settle on the f loor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch.
• Do not use an y phone in y our b uilding .
• Immedia tely call y our g as supplier fr om a neighbor' s
phone . Follow the g as supplier' s instr uctions.
• If you cannot r eac h your g as supplier , call the f ire
department.
C. Do not use this a ppliance if an y par t has been under w ater.
Immedia tely call a qualif ied ser vice tec hnician to inspect
the appliance and to r eplace an y par t of the contr ol system
and an y gas contr ol whic h has been under w ater.
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation of new heater, burn-
ing logs will give off a paper-burning smell. Orange
flame will also be present. Open damper or window to
vent smell. This will only last a few hours.
1.
STOP! Read the saf ety information, above.
2.
Turn off all electr ic po wer to the a ppliance .
3.
Turn wall switch to the OFF position.
4.
Open lo wer louv er panel.
5.
Turn equipment shutof f valve c lockwise
position (see F igure 47). Do not f orce.
6.
Wait five (5) min utes to c lear out an y gas. Then smell f or
gas, inc luding near the f loor. If you smell g as, STOP! Fol-
low "B" in the saf ety information above. If you don' t smell
gas, go to the next step.
7.
Turn equipment shutof f valve counter clockwise
to the ON position. Do not f orce .
8.
Close lo wer louv er panel.
9.
Turn on all electr ic po wer to the a ppliance .
10. Turn the w all switch to the ON position.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
11. Visually locate the pilot. The ignitor should be gin to spar k and
the main b urner should ignite once f lame a ppear s at pilot.
• If lighting the a ppliance f or the f irst time eac h season, it
• If the a ppliance will not sta y lit after se ver al attempts,
Figure 47 - Turning Equipment Shutoff Valve to the OFF Position
1.
Turn off the w all switch.
2.
Turn off all electr ic po wer to the a ppliance if ser vice is to
be perf ormed .
3.
Open lo wer louv er panel.
4.
Remove front hear th br ick and contr ol access panel.
5.
Turn equipment shutof f valve c lockwise
Do not force .
6.
Close lo wer louv er panel.
Figure 48 - Pilot
to the OFF
Clockwise
Note: The WRC receiver and hand-held remote control kit
must be purchased separately (see
installation instructions on page 23.
C-clockwise
1.
Turn equipment shutof f valve to ON position. You can no w turn
the burner on and of f with the hand-held r emote contr ol unit.
IMPORTANT: Be sur e to pr ess the ON/OFF b uttons on the
hand-held r emote contr ol unit f or up to 3 seconds to assur e
proper oper ation.
2.
Press the ON/OFF b utton to tur n the b urner on and of f.
may take se veral attempts bef ore the suppl y gas can r each
the pilot and main b urner s.
follow the instr uctions To Turn Off Gas To Appliance,
below, and call y our ser vice tec hnician or g as supplier .
Equipment Shutoff Valve
TO TURN OFF GAS
TO APPLIANCE
Pilot Burner
OPTIONAL REMOTE
OPERATION
Adjustment
Screw
to OFF.
Clockwise
Sensing Rod
Ignitor
Accessories, page 34). Follow
111922-01A
Advertisement
Table of Contents
