Repairing Components; Removing Components; Used Ports And Ip Addresses - ACRONIS SNAP DEPLOY 2.0 - INSTALLATION FOR PC AND SERVER Installation Manual
Hide thumbs
Also See for SNAP DEPLOY 2.0 - INSTALLATION FOR PC AND SERVER:
Table of Contents
Advertisement
7
Repairing components
During maintenance periods, you may need to repair (or restore) Acronis
Snap Deploy components.
To repair a component:
1.
Run the Acronis Snap Deploy setup procedure
2.
In the Install Menu, click on the component you want to repair.
3.
Click Repair in the Modify, Repair or Remove Installation
window.
8
Removing components
You can remove any Acronis Snap Deploy component separately.
To remove a component from the Control Panel:
1.
Run Control Panel.
2.
Select Add or remove programs.
3.
Click the Remove button on the Acronis Snap Deploy component.
4.
Follow the instructions on the screen.
You can also remove Acronis Snap Deploy components in the Install Menu.
To remove a component from the Install Menu:
1.
Run AcronisSnapDeploy.exe
2.
In the Install Menu, click on the component that is about to be
removed.
3.
Click Remove in the Modify, Repair or Remove Installation
window.
9
Used ports and IP addresses
The Acronis OS Deploy Server and the Acronis Snap Deploy Management
Console use the following ports and IP addresses for remote operation:
port is obtained
if busy, chose port at random
The Acronis PXE server uses following ports and IP addresses:
Acronis Snap Deploy 2.0
UDP port: 9876
TCP port: 9876, if port number is already in use, a random
IPv4 multicast address: 239.255.219.45
IPv6 multicast address: FF05::fAA5:741E
Acronis Snap Deploy Management Console UDP port: 9877,
UDP port: 67, 68, 69.
7
Advertisement
Table of Contents
