ACRONIS BACKUP AND RECOVERY 10 ADVANCED WORKSTATION - COMMAND LINE REFERENCE UPDATE 3 Cli Reference Manual page 13

/partition:1-1,"D"
file_partition:[partition letter]
Specifies the partition where the image file will be stored (by letter or number). This option is used
with filename:[file_name]. In that case the file name must be specified without a drive letter or root
folder. For example:
/file_partition:D /filename:"\1.tib"
Dynamic volumes are specified with the prefix DYN, e.g.:
/file_partition:DYN1 /filename:"\1.tib"
raw
Use this option to create an image of a disk (partition) with an unrecognized or unsupported file
system. This will copy all disk/partition contents sector-by-sector. Without this option only the
sectors containing useful system and user data are imaged (for the supported file systems).
progress:[on | off]
Shows/hides the progress information (percent completed). It is shown by default.
exclude_names:[names]
Files and folders to be excluded from the backup (comma separated). For example:
/exclude_names:E:\MyProject\111.doc,E:\MyProject\Old
exclude_masks:[masks]
Applies masks to select files to be excluded from the backup. Use the common Windows masking
rules. For example, to exclude all files with extension .exe, add *.exe. My???.exe will exclude all .exe
files with names consisting of five symbols and starting with "my".
exclude_hidden
Excludes all hidden files from the backup.
before:[pre-data capture command]
Enables to define the command to be automatically executed before data capture at the beginning of
the backup procedure. For example:
/before:"net stop MSSQLSERVER"
after:[post-data capture command]
Enables to define the command to be automatically executed after data capture at the beginning of
the backup procedure. For example:
/after:"net start MSSQLSERVER"
13 Copyright © Acronis, Inc., 2000-2010