Installation In The Unattended Mode - ACRONIS BACKUP AND RECOVERY 10 ADVANCED SERVER VIRTUAL EDITION - INSTALLATION UPDATE 3 Installation Manual

To install Acronis Backup & Recovery 10 Deduplication
Note: You need to install this component only if you are using a full version of Acronis Backup & Recovery 10.
When using a trial version, you can use deduplication without installing this component.
1. Make sure that the licenses for both Acronis Backup & Recovery 10 Agent for Linux and Acronis
Backup & Recovery 10 Deduplication are imported to the Acronis License Server.
2. After you have installed Acronis Backup & Recovery 10 Agent for Linux, run the installation file:
AcronisDeduplication.i686
3. Specify the license server—either by typing its DNS name or IP address, or by choosing to find the
license server automatically.
4. Follow the on-screen instructions.
To install Acronis Backup & Recovery 10 Management Console or Acronis Backup & Recovery
10 Upgrade Tool
1. Run the installation file:

For Acronis Backup & Recovery 10 Management Console:
AcronisManagementConsoleLinux.i686

For Acronis Backup & Recovery 10 Upgrade Tool: AcronisUpgradeTool.i686
2. Follow the on-screen instructions.
2.6.3

Installation in the unattended mode

To install a component in the unattended mode (without asking for confirmations), run the
component's installation file with the -a command-line parameter. You may need to use other
parameters (p. 30) to specify how to perform the installation.
The following are two examples of unattended installation.
Example 1: Unattended installation with a license key. This example applies to stand-alone editions
of the product and to advanced editions when using a trial license key.
The following command installs Acronis Backup & Recovery 10 Agent for Linux in the unattended
mode (without asking for confirmations) and uses the license key 12345-67890-ABCDE:
./AcronisAgentLinux.i686 -a -i BackupAndRecoveryAgent -l 12345-67890-ABCDE
Note: In stand-alone editions of the product, the file name is AcronisBackupRecoveryServerLinux.i686 instead of
AcronisAgentLinux.i686.
Example 2: Unattended installation with a license server. This example applies to advanced editions
of the product when using a full license key.
The following command:

Installs Acronis Backup & Recovery 10 Agent for Linux in the unattended mode.

Uses Acronis License Server located on the machine licensesrv, and a license key for the Acronis
Backup & Recovery 10 Advanced Server edition.

Registers the machine on Acronis Backup & Recovery 10 Management Server located on the
machine managementsrv once the installation is complete.
./AcronisAgentLinux.i686 -a -i BackupAndRecoveryAgent -L licensesrv -P AS -C
managementsrv -g srvadmin -w PassWd123
29 Copyright © Acronis, Inc., 2000-2010