Dell PowerVault NX3000 Deployment Manual page 19

Setting Up the Target (PowerVault Storage System)
Initiator setup
1 From the PowerVault storage system, go to Start→ Server Manager→
Storage→ Microsoft iSCSI Software Target.
The PowerVault Server Manager Management Console appears.
2 Select Microsoft iSCSI Software Target which is located in the storage
snap-in and right-click on Properties.
3 In the Properties window, select the iSNS tab and add the iSNS server
information (DNS Name or IP address).
NOTE:
4 To create a Target, follow the instructions in "Configuring iSCSI
Connection With the PowerVault NAS Storage System" on page 14.
NOTE:
ensure that the iSCSI Initiator Identifier screen displays all Initiators that are
registered with the iSNS server.
5 To create a virtual disk, follow the instructions in "Creating a Virtual Disk"
on page 16.
Log on - Configuring the Initiator-Target Connection From Initiator (Host)
For information about configuring the Initiator-Target connection, see "Log on -
Configuring the Initiator-Target Connection From Initiator (Host)" on page 17.
Target setup
It is recommended that only NICs for iSCSI network are checked.
During step 7 of Configuring the Target, use the Browse option to
Setup Steps for Initiator-Target Connection
Log on from
Initiator
19