Hard Drive Problems; Keyboard Or Mouse Problems - Fujitsu T4310 - LifeBook Tablet PC User Manual

Problem
LifeBook Tablet PC fails to
recognize DVD/CD-
RW/CD-ROM's.
(continued)
Drive access indicator on
the Status Indicator Panel
blinks at regular intervals
with no disc in the tray.

Hard Drive Problems

You cannot access your
hard drive.

Keyboard or Mouse Problems

The built-in keyboard does
not seem to work.
Possible Cause
Optical drive tray is not
latched shut.
Incorrect or no DVD Player
software is installed.
Wrong drive designator was
used for the disc in the appli-
cation.
DVD/CD-RW/CD-ROM is dirty
or defective.
The Windows auto insertion
function is active and is
checking to see if a disc is
ready to run.
The wrong drive designator
was used by an application
when a bootable disc was
used to start the Tablet PC.
Security is set so your operat-
ing system cannot be started
without a password.
The Tablet PC has gone into
Sleep mode.
109 - Troubleshooting
Possible Solutions
Push on the front of the optical drive tray until it latches. If
that doesn't work, pull out the modular drive latch to remove
the device from the bay, then re-insert the drive until it
latched; this ensures that the drive is properly seated.
Install DVD Player software. (See "Media Player Software" on
page 94 for more information.)
Verify the drive designator used by the application is the
same as the one used by the operating system. When the
operating system is booted from a DVD/CD, drive designa-
tions are automatically adjusted. Note that the drive designa-
tion can be changed with the Disk Management tool located
at Administrative Tools -> Computer Management.
Wipe the disc with a non-abrasive CD cleaning cloth and
reinsert. If it still will not work try another disc in the drive.
This is normal. However, you may disable this feature.
Verify drive designator used by application is in use by the
operating system. When the operating system is booted from
a CD, drive designations are automatically adjusted.
Verify your password and security settings.
Push the Power/Suspend/Resume button.