HP 2000fc Replacement Instructions page 3

6. Turn the thumbscrews until the screws disengage from the module.
7. Rotate both latches downward to disengage the module from the
internal connector.
8. Pull the module straight out of the enclosure.
Installing the new module
1. With the latches in the open position, slide the module into the
enclosure as far as it will go (1). If necessary, press lightly on the
top-center of the module to facilitate insertion.
2. Rotate the latches upward to engage the module with the internal
connector (2) and then, turn the thumbscrews finger-tight (3).
3. Reconnect the cables.
NOTE:
After installing a controller in an operational,
dual-controller system, the new controller automatically
begins to initialize. If the firmware versions differ
between the two controllers, Partner Firmware Upgrade
feature brings the older firmware to the later firmware
level.
4. In operational systems, if additional hardware components, such
as a second controller, need replacing or installing, wait 30 minutes
before proceeding with those procedures. This time frame ensures
that the controller(s) and their ownership of vdisks are fully stabilized.
Verifying proper operation
Examine module status by checking that the OK LED (back) illuminates
green, indicating that the controller has completed initializing and is
online.
If the Fault/Service Required LED is amber, the module has not gone
online and likely failed its self-test. Check the event log for errors and
then restart the controller to put the module online. To restart a controller,
do the following: In the Configuration View panel, right-click the local
system and select Manage > Restart System > Shut Down/Restart, and
select the appropriate options.
If the enclosure UID is on, do the following to turn it off: Select Manage
> General Config > Enclosure Management. Then, click Turn Off Locator
LED.
Page 3