Desa LMFP33NR(B) Owner's Operation And Installation Manual page 18

INSTALLATION
Continued
4. Place crossover log (#4) onto the pin (right) on
back log (#2) and into the recess of the middle
log (#1) (see Figure 28).
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.
Notches
Grate Finger
Figure 27 - Installing Front Log (#3)
(Base may very from illustration)
Figure 28 - Installing Crossover Log (#4)
(Base may very from illustration)
18
INSTALLING BATTERIES FOR
REMOTE RECEIvER AND HAND
HELD REMOTE CONTROL
Four AA batteries and three AAA batteries are
required to operate this heater with the wireless
hand-held remote control set. Four AA batteries
must be installed in the receiver and three AAA
batteries in the hand-held remote control unit.
Note: Only use alkaline batteries.
Installing Batteries in Receiver
1. Locate slot on battery cover of receiver (see
Front Log
2. Insert 4 AA batteries into receiver. Positive
(#3)
3. Slide tab on cover into receiver housing and
4 AA Batteries
Battery
Housing
Backup Switch
Crossover
Log (#4)
Installing Battery into Remote
1. Remove remote cover (see Figure 30).
Peg
2. Insert 3 AAA batteries into remote control (see
Recess
3. Slide remote cover back into place.
3 AAA Batteries
Figure 30 - Installing Batteries in Remote
www.desatech.com
Figure 29). Firmly insert tool such as a small
screwdriver, butter knife or dime into the slot
and lift up to remove cover.
and negative are marked inside receiver
casing. Note: Receiver will not function if
batteries are not installed correctly.
snap cover back into place.
Figure 29 - Installing Batteries in
Receiver
Figure 30). Positive and negative are marked
inside remote control casing. Note: Remote
will not function if batteries are not installed
correctly.
Cover
Control
Cover
Slot
Receiver
Remote
Control
119526-01A