Desa AMITY SDVBPD Owner's Operation And Installation Manual page 24

STOVE AND DIRECT-VENT BURNER SYSTEM INSTALLATION
24
Installing Optional Wireless Hand-Held Remote Control Accessories - (C)GHRCB and (C)GHRCTB Series (Cont.)
Removing/Replacing Glass Door
STOVE AND DIRECT-VENT
BURNER SYSTEM
INSTALLATION
Continued
4. Place receiver into valve bracket and align holes (see Figure 49).
5. Use push-in fasteners included with receiver to secure to
bracket.
6. Connect the wires from the receiver to the valve at TH and
THTP (see Figure 45, page 22).
Figure 49 - Installing Remote Receiver
Installing 9-Volt Alkaline Battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote control unit
2. Attach terminal wires to a 9-volt battery (not included). Place
battery into the battery housing.
3. Replace battery cover onto remote control unit.
Terminal
Wires
9-Volt
Battery
Figure 50 - Installing Battery in Hand-Held Remote Control Unit
(C)GHRCB Series
Terminal
9-Volt
Wires
Battery
Battery Housing
Figure 51 - Installing Battery in Hand-Held Remote Control Unit
(C)GHRCTB Series
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Battery
Remote
Cover
Control Unit
Battery
Housing
Remote
Control
Unit
Battery
Cover
REMOVING/REPLACING GLASS DOOR
You must remove glass door to install logs, lava rock, and ember
material. To remove glass door, you must first remove the front
panel on stove body.
CAUTION: Do not operate this burner system with
a broken glass door panel or without the glass door
panel securely in place. For replacement part infor-
mation see Replacement Parts , page 33.
1. If stove front panel is still installed, remove 2 bolts from bot-
tom of stove and one from the top of stove to remove front panel
(see Figure 52). For the Oxford stove the middle grate will
need to be removed to remove the top bolt.
2. Remove the screws from the 2 tabs at the top of the glass door
while holding door securely keeping it from falling forward
(see Figure 53).
3. Grasp door by both sides and ease it upward off of the lower
bracket (see Figure 53).
4. To replace glass door, follow the above instructions in reverse.
Bolt
Stove Front
Panel
Bolt
Figure 52 - Removing Front Panel from Stove (Oxford™ Model
Shown)
Screw
Glass
Door
Figure 53 - Removing Glass Door from Burner System
Middle
Grate
112126-01B