Advertisement
Product Overview
The IRB-6 provides an effective in-wall method to connect
Infrared components. The IRB-6 can conenct up to 12 infrared
receivers and allows control of up to 8 infrared controlled
devices.
IMPORTANT – Read the manuals that are included with the IR
receivers and other IR equipment you intend to install with the
IRB-6. It is important that you are familiar with the connection
and operation of these devices. If you are unsure of any of the
following installation procedures, this product should be
installed by a professional custom installer.
IR Receiver / Keypad Connections
1) Run 22 gauge, 4 conductor, shielded cable with drain wire,
such as Russound Pt. No. AW2260AB, from each of the IR
receivers or keypads into a standard electrical junction box
as shown in Figure 1.
ROOM A
ROOM B
Figure 1
848
J-BOX
RECEIVER
22 AWG
4 Conductor
Sheilded
Cable w/ Drain
2
IRB-6
drain wire
connected
to GND
terminal
Advertisement
