Advertisement
IRB-1
IR Receiver Connections
1) Connect the 3 conductor 1/8" plug of the tabletop IR receiv-
er, such as Russound Pt. No. 844, to the 1/8" jack located on
the front of the IRB-1 as shown in Figure 2.
2) Following the instructions that came with your IR receiver,
place the IR receiver in a suitable location.
Installation
1) Check all connections, and proper system operation before
installing the IRB-1 into the wall.
IR RECEIVER CONNECTION
848
J-BOX
RECEIVER
22 AWG
4 Conductor
Sheilded
Cable w/ Drain
2) Using the included hardware, install the IRB-1
into a standard electrical box.
844 TABLE TOP RECEIVER
Figure 1
drain wire
connected
to GND
terminal
Figure 2
IRB-6
3
Advertisement
