Advertisement
Quick Links
Advertisement
Related Manuals for Rife DSM
Summary of Contents for Rife DSM
- Page 1 Rife Technologies HEIGHT-ADJUSTABLE DESK ESM www.rifeindia.com Tel : 9899250704...
- Page 2 Part Name End Frame Side Bracket Machine Screws M6*12 Lift Column Foot Leveling Feet Machine Screws M6*10 Control Box Power Cord Cable Handset Wood Screws M5*16 Cable Clips...
- Page 3 Position Lift Column ( Part 4 ) into End Frame ( Part 1 ). Please take care and note the orientation of the End Frame. Must be as shown in the adjacent diagram. Insert 4 pcs M6*12 mm Machine Screws ( Part 3 ).
- Page 4 Place your desktop on the ground with the good side down.Taking care that there is no stray hardware that may damage the top. Ensure the wood screws are not too long for the width of your desktop surface; Otherwise they may puncture it when screwed all the way in! Check that the frame is properly positioned on the underside of the desktop.
- Page 5 Connect the following to the Control Box ( Part 8 ) as show: Handset ( Part 11 ), Cable ( Part 10 ) and Power Cord ( Part 11 ). Use the adhesive-backed Cable Clips ( Part 13 ) to secure all cables neatly.
- Page 6 Almost done .Before using your desk, it is recommend to run through the reset procedure. Press and hold the down arrow on the handset until the desk reaches its lowest height. Release and hold down arrow again until the display reads RST. You will here 1 beep sound the frame will move down slightly then up.
-
Page 7: Up Down Operation
1.The interface of hand controller The key instructions: 2.Initialization Operation When the system is abnormal, or hand controller display the "RST", you need to make lift table initialized, initialization, Press the "DOWN" button, until the motor stopped then after 5 second, enter the initialization mode automatically.At this time can't loosen the "DOWN"... - Page 8 5.The minimum limit set System supports desktop minimum height limit, methods for operation, when it comes to setting the lowest height for the desktop height, the corresponding height at the same time Press the "SET" and "DOWN" button for 5 seconds, the buzzer sound can be heard at this time, is the location of the minimum storage success.
Need help?
Do you have a question about the DSM and is the answer not in the manual?
Questions and answers