Troubleshooting Guide - Desa JourneyMan HD-9260 User Manual

Troubleshooting Guide

If you have a problem, please follow this guide. You may also want to visit our Web site at: www.desatech.com. For
more help call 1-800-858-8501 8:00 AM to 4:30 PM Central Time weekdays.
Lo sentimos, pero no podemos contestar preguntas en español por teléfono.
SYMPTOM POSSIBLE CAUSE
1. Light switch is turned off.
Lights will
2. Flood light is loose or burned out.
not come
3. Fuse is blown or circuit breaker is
on.
turned off.
4. Daylight turnoff is in effect. (Re-
check after dark) .
5. Incorrect circuit wiring, if this is a
new installation.
6. Re-aim the sensor to cover de-
sired area.
Lights
1. Control may be installed in a rela-
come on in
tively dark location.
daylight.
2. Control is in Test. (Set control
switch to an ON-TIME position) .
1. Control may be sensing small ani-
Lights come
mals or automobile traffic. (Re-
on for no
aim sensor or use lens shield) .
apparent
2. Sensitivity is set too high. (Reduce
reason.
sensitivity. Turn Range Boost off) .
598-1007-02
SYMPTOM
POSSIBLE CAUSE
Lights stay on 1. A lamp is positioned too close to the
continuously.
2. Control is pointed at a heat source like
Lights flash
1. Heat or light from the lamps may be
on and off.
2. Reflected heat from other objects are
3. Control is in warming up. (Flashing is
4. Control is in Test. (Set control switch to
-13-
sensor or pointed at objects that causes
the sensor to trigger. (Aim the lamp
away from the sensor or objects) .
an air vent, dryer vent, or brightly-painted
heat-reflective surface. (Re-aim sen-
sor. Turn Boost off).
turning the Light Control on and off.
(Aim lamps away from the sensor. Turn
Boost off).
triggering the sensor. ( Re-aim sensor.
Turn Boost off).
normal under these conditions. Wait 1
minute for sensor to warm up).
an ON-TIME position).