AquaSure AS-FP1500 Owner's Manual

AquaSure AS-FP1500 Owner's Manual

Whole house water filter

Advertisement

FORTITUDE PRO SERIES
WHOLE HOUSE WATER FILTER
OWNER'S MANUAL
FOR MODEL NO.
AS-FP600
AS-FP1000
AS-FP1500

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AS-FP1500 and is the answer not in the manual?

Questions and answers

Summary of Contents for AquaSure AS-FP1500

  • Page 1 FORTITUDE PRO SERIES WHOLE HOUSE WATER FILTER OWNER’S MANUAL FOR MODEL NO. AS-FP600 AS-FP1000 AS-FP1500...
  • Page 3: Table Of Contents

    STEP 3. Mounting the 20” High Flow Sediment Filter STEP 4. Attaching the water supply pipe STEP 5. Installing the filter STEP 6. System startup LIMITED PRODUCT WARRANTY You can also visit online for system installation tutorial. http://www.aquasureusa.com/support AQUASURE FORTITUDE PRO SERIES VER. 1.0 - JUNE 2019...
  • Page 4: Inspection & Preparation

    WELCOME Thank you for choosing Aquasure. Before you start using your Aquasure Fortitude V Series Whole House Water Filter. Please take a few minute to become familiar with the basics. Filter replacement Be Sure to change your Aquasure Filters according to the recommended filter replacement schedule.
  • Page 5: System Operation Parameter And Installation Checklist

    Filtration system must not be installed at an area where it is exposed to direct sunlight and must be protected against freezing and extreme heat. • To prevent possible water damage, housing should be replaced every 4 years. AQUASURE FORTITUDE PRO SERIES...
  • Page 6: Installing The System

    INSTALLING THE SYSTEM IMPORTANT! Locate and test the main water supply valve to the housing before installing the system. If the main water supply valve fails to shut off the water completely during the test, we recommend contacting your local plumber to fix the valve before begin installing the system.
  • Page 7: Step 1. Checking The Direction Of Water Flow

    2. Test to see if the water is completely shut off by turning on the faucet in the cold water position. If the cold water cannot be shut off, please contact your local plumber to fix the valve before begin installing the system. AQUASURE FORTITUDE PRO SERIES...
  • Page 8: Step 4. Attaching The Water Supply Pipe

    STEP 3. Mounting the System 1. Position the system on the wall at the desired mounting location with minimum of 6 in ground clearance from the floor to the base of the system. 2. Using a pen or pencil and mark the mounting hole on the back of the bracket onto the wall.
  • Page 9: Step 5. Installing The Filter

    3. Turn on the nearest faucet and let the water run for 10 minutes to release any trapped air bubble or carbon fine if a carbon filter is installed. CONGRATULATION! Your system is ready to use. Please document the filter installation time and replace the filter in the suggested replacement time. AQUASURE FORTITUDE PRO SERIES...
  • Page 10: Limited Product Warranty

    Aquasure takes pride in selling a superb line of products, including this whole house water filter (“Product”). As such, Aquasure expressly warrants to the original purchaser that, for a period of Five (5) year from the date of purchase, the product will be reasonably free of defects in materials and workmanship.
  • Page 11 The Product is purchased from someone other than Aquasure or one of Aquasure’s authorized dealers. This is because, unless the Product was sold by Aquasure or one of its authorized dealers, Aquasure cannot verify or guarantee the integrity or authenticity of the Product.
  • Page 12 www.AquasureUSA.com | 818 N Mountain Ave #203c, Upland, CA 91786 | 800.661.0680 | sales@aquasureusa.com...

Table of Contents