Sony VPCEB390X Replacement Instructions
Sony VPCEB390X Replacement Instructions

Sony VPCEB390X Replacement Instructions

Hide thumbs Also See for VPCEB390X:

Advertisement

These easy instructions are intended to guide you through the replacement process.
Before you begin, place your notebook computer on a clean or covered surface to avoid
damage to the computer's case.*
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface
of your notebook computer.*
The appearance of the electronic components shown in the illustrations may be different from
the components shipped. This slight difference does not affect the accuracy of these
instructions.
* Sony is not responsible for damage caused by incorrect handling of the notebook computer.

Prepare the Computer

CAUTION:
Make
computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the computer.
Step 1. Place the computer upside
down on a protected surface with the
front edge facing you.
P/N 989201349
Rev. C
VPCEB Series Optical Disk Drive
IMPORTANT!
PLEASE READ BEFORE YOU START
sure
the

Battery Pack Removal

Step 2.
1) Slide the left battery tab to the
unlock position.
2) With your right thumb, slide the
right battery tab to the left and hold.
3)
Lift the battery with your left thumb
using the notch at the bottom to
remove.
Replacement Instructions
1.
2.
3.
Lift to remove
1/3
Optical Drive Removal
(Steps 3-6)
Step 3. The Optical Disk Drive (ODD)
is located on the left side of the unit
as shown.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VPCEB390X and is the answer not in the manual?

Questions and answers

Summarization of Contents

Prepare the Computer
Battery Pack Removal
Instructions for safely removing the notebook computer's battery pack.
Optical Drive Removal Steps
Initial steps for removing the optical disk drive from the computer unit.
ODD Disassembly and Bracket Transfer
Remove ODD Bay Screws
Instructions for removing the two screws securing the ODD Bay.
Remove ODD from Unit
Steps for detaching and gently pulling the Optical Disk Drive from the unit.
Disassemble ODD Brackets
Steps to remove the four side screws and brackets from the ODD.
ODD Assembly and Installation
Prepare New ODD and Bezel
Preparing the new ODD and bezel for assembly, noting tab locations.
Attach Bezel to New ODD
Aligning and carefully pressing the bezel into place on the new ODD.
Attach Brackets to New ODD
Installing the ODD brackets onto the new ODD, ensuring proper alignment.
Insert ODD into Computer
Aligning and sliding the ODD assembly into the computer unit.
Secure ODD Bay and Reinstall
Reinstalling ODD Bay screws, battery pack, and AC adapter.

Table of Contents