Asus AP1710-I5 User Manual page 37

2.6.1 Placing an ATA133 IDE hard disk drive to tray
The following steps describes the installation of a hard disk drive into the
drive tray.
1. Place the hard disk tray on a flat
clean surface. Prepare Philips
(cross) screwdriver.
2. Remove middle bracket. To
release from pin, unscrew rear
bracket and slowly detach middle
bracket. Take caution in handling
the drive tray, the plastic drive
tray rail may break.
3. Replace the rear bracket and
fasten with screws.
User's Manual
Rear bracket
Middle bracket
Drive tray rail
2-19