Connecting To The Intuikey - Bosch KBD-DIGITAL Installation Manual

IntuiKey Keyboard
3.2

Connecting to the IntuiKey

1.
CAUTION! To ensure proper system functioning and to prevent damage to the unit, it is
!
critical that only Allegiant devices be connected to the Allegiant connector, and that
Multiplexer/DVR devices be connected to the MUX/DVR connector.
2.
3.
NOTICE! In systems having multiple Divar Series DVRs or multiple System4 Multiplexers, use
i
the front panel controls on the video devices to assign appropriate address numbers and
starting camera numbers. The IntuiKey will not properly recognize the video devices if there
are conflicting addresses in the system.
Bosch Security Systems, Inc.
Refer to Figure 3.8 for details on the input/output connections supplied by the IntuiKey
Keyboard. Four connectors are located on the IntuiKey rear panel: (2) RJ-11 connectors,
(1) female 9-pin sub-D connector, and a DC power jack. The RJ-11 connectors are labeled
as Allegiant and MUX/DVR and the 9-pin sub-D is labeled RS-232 Serial Port.
MUX/DVR
MUX / DVR
Figure 3.3 Back Panel Connections of IntuiKey
If desired, the data/power cables can be looped through either of the two tabs found at
the bottom of the rear panel to increase strain relief capabilities.
Review the configuration options shown in Figure 3.9. Make the necessary keyboard data
and power connections that are best suited to your system requirements based on these
diagrams. When connecting to a Divar Series DVR or to a System4 Multiplexer, attach the
supplied 390 ? terminator to the Out connector on the last device.
Installation Manual
Allegiant RS-232
DC Power Serial Port
ALLEGIANT 12 VDC RS-232 SERIAL PORT
Cable Strain Reliefs
Installing the IntuiKey Keyboard | en
F.01U.115.018 | 1.92 | 2008.12
13