Advertisement
Vertical position Horizontal position
Mounting the center speaker
Place the center speaker on top of the TV, on the floor under
the TV or inside the TV rack so that it is stable.
When placing the speaker on top of the TV, put the provided
Velcro
TM
strips at two points on both the bottom of the speaker
and on top of the TV to prevent the speaker from falling.
Notes
Do not place the speaker on top of the TV whose area is smaller than the bottom area of
the speaker. The speaker may fall and might cause personal injury.
Though this speaker is a magnetically shielded type, there may be some influence on a
TV picture depending on the type of TV or the placement of the speaker. In such a case,
place the speaker apart from TV so that there is no influence on TV picture.
Mounting the main and rear speaker
Please place rubber feet as shown in the diagram
prior to mounting the speakers on the wall.
Min.
20mm
6mm
Min.
20mm
6mm
Min.
20mm
6mm
Tapping screw
(Available at the
hardwarestore)
WARNING
Each speaker weight 1.76 lbs (0.80kg). Do not mount them on thin plywood or soft
surface material. If mounted, the screw may come out of the flimsy surface and the
speakers may fall. This damages the speakers or causes personal injury.
Do not install the speakers to a wall with nails, adhesives, or any other unstable
hardware.
To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall.
Secure installation is the purchaser's responsibility.
Main and rear speakers can be positioned
horizontally or vertically.
Please install rubber feet included to prevent
slipping movement.
Please note: Logo can rotate.
Fasten screws into a film wall or wall
support as shown in the figure, and hang
the holes of the mounting bracket on the
protruding screws.
Make sure that the screws are securely
caught by the narrow sections of the "key
hole" opening. Main and rear speakers can
be mounted horizontally or vertically.
This speaker is designed to be used as a main, center, surround or effects speaker
- Main speaker placement should be separated by distance of 6-10ft. If they are placed
too close together, there will be a reduction in the stereo effect.
Conversely. If placed too far apart, the so called middle-omission effect will occur and
the vocal center fill will be lost. Height of the speaker should be at least at ear level.
- Center channel speakers should be placed centered above or below the TV.
- Surround speakers should ideally be placed behind the listening area. At least as far
apart as the main speakers and up to 2 additional feet apart per side. The height of the
speaker should be at a minimum of ear level or preferably somewhat higher.
Left Main Speaker
up to approx
2 feet more
Left Surround Speaker
Model
Center Speaker
Type
Speaker: Woofer
Speaker: Tweeter
Frequency Range
Impedance
Nominal Input
Maximum Input
Sensitivity (dB/2.83v. 1m)
Crossover Frequency
Dimension (H W D)
Weight
Finish
Magnetic Shielding
Main and rear
Type
Speaker: Woofer
Speaker: Tweeter
Frequency Range
Impedance
Nominal Input
Maximum Input
Sensitivity (dB/2.83v.ln)
Crossover Frequency
Dimension (H W D)
Weight
Finish
Magnetic Shielding
Accessories
*Specifications subject to change without notice due to product improvements.
2
Center Channel Speaker
Right Main Speaker
Rear Center Surround Speaker
Left Surround Speaker
NS-AP2400
NS-AP2400C
2-way Acoustic Suspension
Dual 2
" Pulp cone and Rubber surround
3/4
1/2" Balanced dome
90Hz ~ 50kHz (-10dB)
6 ohms
30w
100w
80dB
4,500Hz
3
" 9
" 4
" (92 250 111mm)
5/8
7/8
3/8
2,51lbs(1.14kg)
Silver and Black
Yes
NS-AP1400S
2-way Acoustic Suspension
2
" Pulp core and Rubber surround
3/4
" Balanced dome
1/2
90Hz ~ 50kHz (-10dB)
6 ohms
30w
100w
80dB
4,000Hz
6
" 3
"
"(168 92 106mm)
5/8
5/8
1/8
1.76 lbs (0.80kg)
Silver and Black
Yes
120" Bulk Speaker Wire
3/8
"
3/32
" Rubber foot 16pcs
1
" 2" Velcro
TM
2pcs
17/32
up to approx
2 feet more
Advertisement
