Using Your Humidifier - Hunter 33200 Manual

Using Your Humidifier

1. Remove The Care-Free Humidifier Plus™ Evaporative Humidifier from its pack-
aging. Read and Save the Instructions.
2. Place the humidifier on a hard, flat, water resistant surface. Always place the hu-
midifier at least six (6) inches away from walls and sources of heat.
3. Lift the main housing and be sure that the PermaWick™ filter frame is placed
upright in the slots. Replace the main housing. (See Figure 1.)
4. Remove the water tank and take it to the sink or tub to fill.
5. Turn the tank upside down and unscrew the tank cap by turning it counter-clock-
wise. Fill the water tank with cool water and replace the tank cap (Never use hot
water). Be sure not to overfill the tank as water damage may occur to furniture or
flooring due to spillage. HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR
DAMAGE TO PROPERTY CAUSED BY WATER SPILLAGE.
6. Carry the tank back to the humidifier. Turn the tank upright and place it on the
humidifier. Be sure that the tank is seated properly in the base. If the tank is prop-
erly located on the base, you will see air bubbles flowing up into the tank.
7. With the power control knob in the 'OFF' position, plug the humidifier into the
wall.
CAUTION: Never plug in the Humidifier while your hands are wet as Electric
Shock could occur.
8. Use the power control knob to turn the humidifier 'ON' by selecting a 'HI' or
'LO' setting.
Only for models with a Adjustable Humidistat
(33280, 33301, 33331, 37250, 37300 and 37350):
9. You can choose the desired humidity output by adjusting the Adjustable Humidis-
tat knob. In a very dry room, the "HI" setting should be used to quickly achieve a
comfortable level of humidity. Once the room is comfortable, you can turn the
Adjustable Humidistat down. Selection of your desired humidity level is a personal
choice and you may have to adjust the dial to find the level where you feel most
comfortable. To begin with, we suggest you try a middle location between the lowest
and the maximum setting. Then, adjust the level to suit your needs.
10. When the humidity reaches the level you have set, the "Desired Humidity" light
will be illuminated. The humidifier will not output humidity while the humidity in
the room is at the selected humidity level. The "Desired Humidity" light will stay
on until the humidity changes. When the humidity in the room drops below the
selected level, the humidifier will cycle on again and the "Desired Humidity" light
will go off.
41284-01 09/23/2003 7 © 2003 HUNTER FAN CO.