Related Manuals for Siemens Synco RMU730
Summarization of Contents
KNX (Konnex) and Synco
General overview
Introductory information about Synco and the KNX network, and KNX Association.
Definition of terms
Explains key terms related to KNX bus, topologies, access methods, and LTE mode.
Synco 700, 900, RXB/RXL range
Lists Synco devices with KNX TP1 interface and their applications.
The KNX network
Details the structure and components of a full-scale KNX network.
Area/line couplers and IP router
Explains the function and use of area/line couplers and IP routers in KNX networks.
Engineering notes
Designing the network
Outlines the procedure for designing a KNX network, including criteria and steps.
Bus power supply
Describes the requirements and types of bus power supply for KNX networks.
Bus topologies
Explains permissible bus topologies and connection variants for KNX.
Commissioning notes
Points to check prior to commissioning
Lists essential checks and requirements before starting the commissioning process.
Commissioning with the RMZ operator units
Details the procedure for commissioning Synco 700 controllers using RMZ operator units.
Device address and device name
RM… controllers
Covers reading and assigning device addresses and names for RM controllers.
Setting device address with RMZ790 and RMZ791 operator units
Step-by-step guide for setting device addresses using RMZ operator units.
Device addresses via ACS
Service tool OCI700.1 and ACS7… software
Overview of the OCI700.1 service tool and ACS7 software for device management.
RM… controller device address
Methods for assigning device addresses to RM controllers using ACS Service.
Device address for the RXB/RXL room controllers
Procedure for setting device addresses for RXB/RXL room controllers.
Addressing the IP router
Configuration of KNX network addresses for IP routers.
Basic communication settings
RM… controllers
Configuring basic communication settings for RM controllers.
Basic settings via ACS
Modifying basic settings for devices using the ACS Service software.
Communication via zone addresses
Synco zoning
General notes on Synco zoning and its application with KNX devices.
Communication of process values
Explains process value exchange in LTE mode using zone addresses.
Zone addressing with the RMZ operator units
Setting zone addresses for RM controllers using RMZ operator units.
Addressing the zones with ACS
Using ACS Service to set zone addresses for various controllers.
Large plants
Engineering and commissioning
Key considerations for designing and commissioning large KNX plants.
Network topologies
Illustrates KNX network topologies including area, line, and IP router configurations.
LTE filter table for couplers and IP routers
Details LTE filter settings for managing data traffic with couplers and IP routers.
Engineering of large plants
Using ACS software for engineering large plants, including IP addressing.
Appendix
Faults and errors
Covers communication errors, fault status messages, and error types.
Heating / cooling changeover
Explains the H/C changeover function and its programming methods.
Room control combination
Details application examples for combining room controllers for unified operation.
Lightning and overvoltage protection, EMC
Discusses protection measures against lightning, overvoltage, and EMC.
Need help?
Do you have a question about the Synco RMU730 and is the answer not in the manual?
Questions and answers