Stahls Hotronix Fusion IQ XRF2 Controller Replacement Manual

Fusion (Model XF)
Fusion (Model XF)
Controller V4.5 & TRIAC Replacement
Controller V4.5 & TRIAC Replacement
2015-03-08
Controller Replacement Guide
2015-03-08
Fusion IQ ( XF/XRF/XRF2)
1
1
1. Required Tools: Paper Clip
5
5
2. CAUTION: Turn off power and detach power cord
8 9
9
8 10
10
11
3. Insert the Paper Clip into the small hole on either
side of the housing
4. Press in the Paper Clip until two clicks are heard:
the first click releases the Controller bezel and the
second click ejects it from the housing as shown
Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals
3
3
2
2
6
6
7
7
12
14
12
14
13
13
11
4
Included Parts:
4
5. Repeat the process on the other side of housing
Included Parts:
1. Controller
1. Controller
Included Parts:
2. Controller Overlay
2. Controller Overlay
3. Temperature strips 1. Controller
3. Temperature strips
4. Zip ties
2. Triac
4. Zip ties
5. TRIAC
3. Temperature Strips
5. TRIAC
6. Adapter Harness (older models only)
6. Adapter Harness (older models only)
7. 9-Pin Connector (where applicable)
Required Tools:
7. 9-Pin Connector (where applicable)
1. Allen Wrenches (1/8" & 9/64")
Required Tools:
Required Tools:
2. #2 Phillips Screwdriver
8. Allen Wrenches (3/32" & 9/64")
8. Allen Wrenches (3/32" & 9/64")
3. Needle Nose Pliers
9. #2 Phillips Screwdriver
9. #2 Phillips Screwdriver
10. #1 Phillips Screwdriver
4. Scissors
15
6. Remove the old Controller and insert the new
10. #1 Phillips Screwdriver
15 11. 2mm Precision Flathead Screwdriver
5. Paper Clip
replacement Controller 11. 2mm Precision Flathead Screwdriver
12. Scissors
12. Scissors
13. Wire Cutters (9-pin repair only)
13. Wire Cutters (9-pin repair only)
14. Wire Strippers (9-pin repair only)
14. Wire Strippers (9-pin repair only)
15. Permanent Marker (9-pin repair only)
15. Permanent Marker (9-pin repair only)
CAUTION: Detach power cord before
CAUTION: Detach power cord before
proceeding
7. Press on the two latch points with your thumb until
proceeding
a click is heard; if the Controller bezel does not sit
flush with the housing plastic, it has not latched
8. Plug in and turn on heat press to verify function
1-800-727-8520 Page 1 of 1
www.hotronix.com 2018-04-26
Page 1 of 15
Page 1 of 17
Page 1 of 17