GAS GAS EC 200 Workshop Manual page 15

Engine 200 cc / 250 cc / 300 cc
EC ENDUCROSS WORKSHOP MANUAL
Ed: 07/05 FITTING THE ENGINE ON THE CHASSIS 02-03
- Remove the oil filler cap -arrow- and fill with new transmission
oil.
Viscosity: 10W30
Capacity 900 cc
- Fit the oil filler cap with a new gasket and tighten.
- Pump the starter pedal 3 or 4 times and check the oil level
through the indicator -arrow-.
- Apply Nural 29 to the exhaust system unions.
- Fit the complete exhaust system and tighten screws slightly.
- Check the condition of the O-rings of the exhaust; if they
are deteriorated, replace them.
- Correctly fit the springs holding the exhaust pipe to the
cylinder pipe.
- Tighten the exhaust system screws.
Tightening torque: 6 Nm