Remote Operation - Desa FVFM27PR Owner's Operation And Installation Manual

OPERATING HEATER
Continued
OpTIONAL HAND-HELD

REMOTE OpERATION

All remote control accessories must be pur-
chased separately (see Accessories, page 25).
Follow instructions included with the remote
control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 16.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 25). Note:
The burner may light if hand-held remote was
on when selector switch was last turned off.
You can now turn the burner on and off with
the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Piezo
Flame
Ignitor
Adjustment Knob
Selector Switch in Remote Position
(Optional Hand-Held Remote Control)
Figure 25 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Hand-Held Remote Operation
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held
remote until burner turns on. Hold the con-
trol button again until burner turns off (see
Figure 26).
To Lock press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock press both buttons together on hand-
held remote control until the light stops flashing.
The hand-held remote is now unlocked.
18
Control Knob
in On Position
ON
OFF
REMOTE
www.desatech.com
Indicator
Light
Figure 26 - On/Off Hand-Held Remote
Control Unit
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 27). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Locks
System to
Prevent
Accidental
ROOM
TEMP
Ignition
LOCK
Turns
Burners
On or Off
MANU
Increases or
Decreases
Room
Temperature in
AUTO Mode
Figure 27 - Thermostat Hand-Held
Remote Control Unit
Manual Mode
1. Press the POWER and LOCK buttons togeth-
er to turn on the hand-held remote control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the fireplace
Control
Button
Digital Display Shows
Temperature and Settings
Turns Hand-
AUTO
SET
Held Remote
TEMP
On or Off and
TEMP
Allows You
POWER
to Choose
the Manual
AUTO
ºC/ºF
Setting
Selects
AUTO
Mode
°C/°F Mode Button
108382-01G