Table of Contents
Advertisement
CAST IRON FIREPLACES
ASSEMBLY & OPERATING INSTRUCTIONS
Important: Read these instructions for use carefully so as to familiarize yourself with the
appliance before connecting it to its gas container. Keep these instructions for future
reference. Megamaster reserves the right to make changes to this manual without prior
notice.
www.megamaster.co.za
Manufactured in China · Distributed by Mega Group · PO Box 15, Woodlands, 0072, South Africa · Tel: +27 (0) 12 802 1515
1
Advertisement
Table of Contents
Related Manuals for Megamaster Turano
Summarization of Contents
Introduction and Warranty Information
Guarantee and Warranty Details
Covers the fireplace guarantee period, what is covered, and conditions.
Warranty Exclusions and Inspections
Lists items not covered by warranty and the importance of pre-installation inspection.
Product Installation and Safety Warnings
Installation Requirements and Installer Qualifications
Details requirements for qualified installers and installation compliance.
Essential Pre-Installation Instructions
Emphasizes reading all instructions carefully before proceeding with installation.
General Safety Guidance for Fireplace Use
Key Safety Precautions
Provides critical safety advice on hot surfaces, fire hazards, and carbon monoxide.
General Safety, Unpacking, and Assembly
General Safety Rules and Compliance
Outlines general safety, installation compliance, and operation practices.
Unpacking and Required Tools
Details unpacking procedures and lists necessary tools for assembly.
Assembly and Installation Guidelines
Supporting Floor and Hearth Specifications
Specifies requirements for floor load capacity and hearth construction.
Material Clearance Requirements
Defines minimum clearances from combustible materials and ceilings.
Chimney System Requirements
Flue Pipe Sizing and Connection Standards
Specifies flue pipe diameter requirements based on heat output and connection standards.
Flue Installation, Liners, and Safety Notes
Guides on installing flue liners, sealing joints, and avoiding shared chimneys.
Flue Height and Bend Regulations
Optimal Flue Height and Positioning
Discusses chimney height and positioning for optimal combustion discharge.
Rules for Flue Bends and Offsets
Details acceptable rules for offsets and bends in the flue system.
Inspection and Cleaning Procedures
Air Supply for Combustion
Specifies permanent air vent opening sizes for adequate combustion.
Chimney Connection and Flue Access
Details requirements for connecting the fireplace to the chimney and flue access.
Using Your Megamaster Fireplace
Managing Fume Emissions
Advises on preventing and responding to fume emissions during operation.
Understanding Fireplace Controls
Explains how primary and secondary air supplies regulate heat output.
Fuel Selection and Fireplace Seasoning
Recommended Fuel Types and Quality
Details suitable fuels, moisture content, and prohibited materials.
Initial Seasoning Procedure for New Fireplaces
Outlines the steps for initial fireplace seasoning to prevent metal cracking.
Operational Procedures for Fireplace Use
Safe Fire-Lighting with Wood
Provides step-by-step instructions for lighting a fire safely.
Refuelling and Burn Rate Control
Guides on safely refuelling and managing the burn rate for efficiency.
Ash Removal and Disposal
Explains how and when to remove ash from the fireplace for optimal performance.
Accessories and Product Disposal
Recommended Fireplace Accessories
Directs users to the website for flue kits and other fireplace accessories.
Responsible Product Disposal
Provides instructions for disposing of the product and components responsibly.
Troubleshooting Common Fireplace Issues
Problem Diagnosis and Solutions
Lists common fireplace problems and their corresponding solutions.
Fireplace Maintenance and Care
Cleaning the Fireplace Interior
Details how to clean the inside of the fireplace, including safety precautions.
General Maintenance Checks and Advice
Advises on checking for damaged parts and contacting customer service.
Fireplace Body Care and Rust Prevention
Covers cleaning, repainting, and treating surface rust on the fireplace body.
Chimney and Flue Maintenance
Chimney Sweeping Schedule and Best Practices
Recommends the frequency for sweeping chimneys based on fuel type and best practices.
Need help?
Do you have a question about the Turano and is the answer not in the manual?
Questions and answers