Replace Oven Racks And Warming Drawer; Storage Drawer - Whirlpool GFG461LVS - 30 Inch Gas Range Installation Instructions Manual

Check Operation of Oven Broil Burner
1. Close the oven door.
2. Press the BROIL pad.
3. Press the START pad.
The oven burner should light within 8 seconds. Under certain
conditions, it may take the burner up to 50 to 60 seconds to light.
Refer to the Use and Care Guide for proper operation of the oven
controls.
Adjust Oven Broil Burner Flame (if needed)
Look through oven window to check broil burner for proper
flame. This flame should have a ½" (1.3 cm) long inner cone of
bluish-green, with an outer mantle of dark blue, and should be
clean and soft in character. No yellow tips, blowing or lifting of
flame should be present.
If flame needs to be adjusted:
1. Loosen the lock screw on the air shutter located at the rear of
the broil burner.
2. Adjust the air shutter as needed.
3. Tighten lock screw.
A
B
A. Lock screw
B. Air shutter
4. Press CANCEL/OFF when finished.
Replace Oven Racks and
Warming Drawer
Replace oven racks in oven cavity. Replace warming drawer.
To Replace Warming Drawer:
1. Insert warming drawer into slide rails on sides of drawer
opening.
2. Lift front of drawer slightly and push firmly to close drawer.

Storage Drawer

The storage drawer can be removed. Before removing, check
that the storage drawer is cool and empty. A flat-blade
screwdriver will be needed for removal.
To Remove:
1. Pull the storage drawer forward to the drawer stop. Push the
drawer back approximately 1" (2.5 cm).
It will be necessary to disengage the storage drawer one side
at a time.
2. Insert a flat-blade screwdriver through the opening in the side
of the storage drawer, placing the screwdriver tip on the
outside of the drawer clip.
A. Drawer clip
3. Depress the drawer clip by pressing the screwdriver handle
toward the side of the storage drawer.
A
A. Drawer clip - view from outside of storage drawer
4. Gently pull forward on the storage drawer until the depressed
clip clears the drawer glide.
5. Repeat steps 2-4 for the other side of the storage drawer.
6. Lift up the back of the storage drawer and remove.
To Replace:
1. Lift up the back of the storage drawer and place it inside the
range in its fully forward position.
2. Lift up the front of the storage drawer to a level position.
3. Slowly push the storage drawer into the range until the
drawer side rails engage with the gap in the drawer glides.
A. Engage drawer glide.
4. Once the storage drawer is fully engaged on both sides, slide
the drawer back into the closed position.
5. NOTE: When you are removing and replacing the storage
drawer, a slight push may be needed to move the drawer
stop notch past the drawer glides.
A
A
11