Table of Contents
Advertisement
CONTINENTAL AIRCRAFT ENGINE
MAINTENANCE
MANUAL
STANDARD PRACTICE
FOR SPARK IGNITED ENGINES
Technical Portions Accepted by the Federal Aviation Administration
Publication M-0
Change 4
©
2017 CONTINENTAL MOTORS
JUL 2017
Advertisement
Table of Contents
Related Manuals for CONTINENTAL AIRCRAFT ENGINE IO-550
Summarization of Contents
Introduction and General Information
1-1. Scope and Purpose of This Manual
Defines the manual's scope and applicability to specific engine models.
1-1.1. Instructions for Continued Airworthiness
Lists related manuals for engine airworthiness and maintenance requirements.
1-1.2. Advisories
Explains the different types of advisories (WARNING, CAUTION, NOTE) used in the manual.
1-1.3. Effectivity Symbols
Details symbols used to indicate applicability to specific engine models or configurations.
1-1.4. Using this Manual
Provides guidance on how to effectively navigate and utilize the manual's content.
1-2.4.1. Service Documents Incorporated
Lists service documents and bulletins integrated into this manual for technical updates.
Lubricants, Sealants, and Adhesives
Table 3-4. Sealants
Details specific sealants, their part numbers, applications, and remarks.
Table 3-5. Lubricants
Lists lubricants, their part numbers, applications, and applicable engine models.
Engine Inspection and Service Procedures
6-4.7.5. Magneto RPM Drop Check
Procedure for performing a magneto check to ensure proper ignition system function.
6-4.7.6. Engine Shutdown
Step-by-step instructions for safely shutting down the engine after operation.
6-4.8.2. Oil Change
Detailed procedure for performing routine engine oil and filter changes.
Engine Operation
Table 7-1. Aviation Fuel Specifications
Outlines specifications and colors for various aviation gasoline grades.
Table 7-2. Authorized Fuels by Engine Model
Lists authorized fuels for different Continental engine models based on type certificate.
7-2.3. Operation after Cylinder Replacement/Overhaul
Procedures for operating engines after cylinder replacement or major overhaul for proper break-in.
Non-Overhaul Repair and Replacement
10-6.1.2. Cylinder Installation
Step-by-step guide for installing cylinders on the engine, including critical warnings.
10-6.1.3. Cylinder Torque
Specific torque sequences and values for cylinder installation and assembly.
10-10.2. Solid Nose Oil Seal Installation
Detailed procedure for installing the solid type crankshaft nose oil seal.
10-10.3. Split Nose Oil Seal Removal
Instructions for removing split type crankshaft nose oil seals.
10-10.4. Split Type Nose Oil Seal Installation
Detailed procedure for installing the split type crankshaft nose oil seal.
Appendix B: Torque Specifications
Table B-2. Component Specific Torque Specifications
Comprehensive table of torque values for various fasteners and components.
Appendix C: Maintenance Standards
C-2.4. Mandatory Overhaul Replacement Parts
Lists parts that must be replaced with new ones during engine overhaul.
C-9. Gasket Maker® Application
Guidelines for the correct application of Gasket Maker sealant.
C-10. Gasket Installation
Procedures for proper installation of gaskets and related components.
C-10.1. Crush Washer Installation
Instructions for installing and torquing crush washers for sealing.
Need help?
Do you have a question about the IO-550 and is the answer not in the manual?
Questions and answers