Table of Contents
Advertisement
11.
WARNING!
fore using this product on a running engine. Electromagnetic fields in close proxim-
ity to a heart pacemaker could cause interference or failure of the pacemaker. In
addition, people with pacemakers should adhere to the following: Caution is neces-
sary when near the coil, spark plug cables, or distributor of a running engine. The
engine should always be off if adjustments are to be made to the distributor.
12.
WARNING! The brass components of this product contain lead, a chemical
known to the State of California to cause cancer and birth defects (or other repro-
ductive harm). (California Health & Safety Code § 25249, et seq. )
13.
WARNING!
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which can-
not be built into this product, but must be supplied by the operator.
ASSEMBLY AND OPERATING INSTRUCTIONS
To Bleed Brakes:
1.
Attach a 3" Vacuum Hose (5) to the bottom of the Jar Lid (2a). (See Figure A.)
2.
Attach a 23" Vacuum Hose (4) to the top of the Jar Lid (2a) marked "TO PUMP".
Then, attach the other end of the 23" Vacuum Hose to the Brake Bleeder/Vacuum
Pump (1). (See Figure A.)
3.
Firmly attach the Jar Lid (2a) to the Reservoir Jar (3). (See Figure A.)
4.
Remove the cap from the vehicle's master cylinder, and check to make sure the
23"
VACUUM
HOSE
(4)
3"
VACUUM
HOSE
(5)
TO WHEEL CALIPER BLEEDER SCREW
SKU 92474
For technical questions, please call 1-800-444-3353.
People with pacemakers should consult their physician(s) be-
The warnings, precautions, and instructions discussed in this
JAR LID (2a)
23" VACUUM HOSE (4)
RESERVOIR JAR (3)
BRAKE BLEEDER SCREW ADAPTER (9)
GAUGE
VACUUM
RELEASE
CONTROL
BRAKE BLEEDER/
VACUUM PUMP
(1)
FIGURE A
PAGE 5
Advertisement
Table of Contents
