Do you have a question about the 46149 and is the answer not in the manual?
Questions and answers
scott weathers
May 24, 2025
How long should it take to evacuate 5 qts of oil on average
1 comments:
Mr. Anderson
May 25, 2025
The average time to evacuate 5 quarts of oil using Central Pneumatic part number 46149 is about 60–80 seconds.
This answer is automatically generated
mark
March 3, 2025
i need the whole top piece mine fell over and broke
1 comments:
Mr. Anderson
March 3, 2025
The manual states that some parts are shown for illustration purposes only and are not available individually as replacement parts. It also advises that all repairs and part replacements should be undertaken by certified and licensed technicians. For technical questions or replacement parts, you can call 1-800-444-3353.
Page 1
OIL EXTRACTOR 6 1/4 GALLON 46149 SET up ANd OpERATING INSTRuCTIONS distributed exclusively by Harbor Freight Tools ® 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our website at: http://www.harborfreight.com Read this material before using this product. Failure to do so can result in serious injury.
Page 2
Do not minor or moderate injury. wear loose clothing or jewelry as Page 2 For technical questions, please call 1-800-444-3353. SKU 46149...
Page 3
Tank (1) with Ball Valve technician. open. uSE THE RIGHT pROduCT FOR IF uSEd OIL dOES NOT THE RIGHT jOB. There are certain EVACuATE TANK (1) upON SKU 46149 For technical questions, please call 1-800-444-3353. Page 3...
Page 4
It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. REV 09h Page 4 For technical questions, please call 1-800-444-3353. SKU 46149...
Page 5
Hose (5) and attach it to the probe inserted in the dip stick tube. Secure over the two rubber gaskets in the Assembly. It should feel secure. See Figure D. SKU 46149 For technical questions, please call 1-800-444-3353. Page 5...
Page 6
(Horizontally). Remove Probe from vehicle. Detach and close off Hose by putting on attached Cap. Disconnect Air Compressor. Remove Emptying Cap (9) and manually drain oil into an oil recycling container. Page 6 For technical questions, please call 1-800-444-3353. SKU 46149...
Page 7
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 46149 For technical questions, please call 1-800-444-3353. Page 7...
Page 8
• Camarillo, CA 93011 • (800) 444-3353 not apply to you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS. Page 8 For technical questions, please call 1-800-444-3353. SKU 46149...
Need help?
Do you have a question about the 46149 and is the answer not in the manual?
Questions and answers
How long should it take to evacuate 5 qts of oil on average
The average time to evacuate 5 quarts of oil using Central Pneumatic part number 46149 is about 60–80 seconds.
This answer is automatically generated
i need the whole top piece mine fell over and broke
The manual states that some parts are shown for illustration purposes only and are not available individually as replacement parts. It also advises that all repairs and part replacements should be undertaken by certified and licensed technicians. For technical questions or replacement parts, you can call 1-800-444-3353.
This answer is automatically generated