This Stand is used to support automobile exhaust systems and drive shafts underneath an
already hoisted vehicle. The Stand will allow hands free repair after the required part is sup-
ported.
note!!
The Two Ton High Jack Stand is 24" wide and can be used at a minimum height of
49 3/4" and a maximum height of 93 1/2".
1.
Use for intended purposes only.
2.
Use on flat, level, hard surface capable of supporting stand and load.
3.
Inspect before use; do not use if parts loose or damaged.
4.
Do not exceed 4,000 lb. maximum weight capacity.
5.
Wear ANSI-approved safety goggles and heavy-duty work gloves during use.
6.
Read manual before set up and/or use.
7.
Make sure the hoist used to lift the car or truck is in good working order and securely
locked into place after reaching desired height.
The Legs (#8) of the High Jack Stand must stand on a dry, clean, hard, level surface.
1. Turn the Handles (#10) so that the Pan (#10) retracts back into the Screw Rod (#2) as
far as it will go.
2. Position the Pan (#10) directly underneath the auto part you wish to support.
3. Remove the Lock Pin (#11) and raise the Shaft (#6) so that the Pan (#1) rests under the
selected auto part needing support. Reinsert the Lock Pin (#11).
4. Turn the Handles (#10) raising the Pan (#1) until it securely supports the auto part.
Make sure there is no wobble. If necessary tighten Handles (#10).
SKU 41860
General Usage
Safety Warnings
Operation
REV 07k
Page 3