Page 1
Model 41860 2 Ton Underhoist Safety Stand SeT Up anD OpeRaTing inSTRUcTiOnS Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Distributed exclusively by Harbor Freight Tools ®...
Page 2
9. Take the assembled Shaft (#6) and insert it into the tube of the Base Stand (#7). Lower it to the desired level and insert the Lock Pin (#11) to secure it at the appropriate height. SKU 41860 Page 2...
Reinsert the Lock Pin (#11). 4. Turn the Handles (#10) raising the Pan (#1) until it securely supports the auto part. Make sure there is no wobble. If necessary tighten Handles (#10). SKU 41860 Page 3 REV 07k...
Assembly Drawing and Parts List Description Screw Rod Screw Nut Bearing Position Rod Shaft Base Stand Legs Down Support Handle Lock Pin Bolt M10x20 Nut M10 Washer #10 Upper Support Mid Support SKU 41860 Page 4...
BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 41860 Page 5 REV 07k...